Control co-design of 13 MW downwind two-bladed rotors to achieve 25% reduction in levelized cost of wind energy

A gravo-aeroelastically scaled wind turbine rotor at field-prototype scale with strict structural requirements

(2020) Shulong Yao et al.   RENEWABLE ENERGY

Ground testing of a 1% gravo-aeroelastically scaled additively-manufactured wind turbine blade with bio-inspired structural design

(2019) Meghan Kaminski et al.   RENEWABLE ENERGY

Analytic analysis of load alignment for coning extreme‐scale rotors

(2019) Carlos Noyes et al.   WIND ENERGY

Extreme-scale load-aligning rotor: To hinge or not to hinge?

(2019) Carlos Noyes et al.   APPLIED ENERGY

Tower shadow induced blade loads for an extreme‐scale downwind turbine

(2019) Carlos Noyes et al.   WIND ENERGY

Nested and Simultaneous Solution Strategies for General Combined Plant and Control Design Problems

(2018) Daniel R. Herber et al.   JOURNAL OF MECHANICAL DESIGN

Measurements and predictions of wind turbine tower shadow and fairing effects

(2018) Carlos Noyes et al.   JOURNAL OF WIND ENGINEERING AND INDUSTRIAL AERODYNAMICS

Pre-aligned downwind rotor for a 13.2 MW wind turbine

(2018) Carlos Noyes et al.   RENEWABLE ENERGY

Critical review of offshore wind turbine energy production and site potential assessment

(2018) Iñaki Arrambide et al.   ELECTRIC POWER SYSTEMS RESEARCH

Teeter design for lowest extreme loads during end impacts

(2017) V. Schorbach et al.   WIND ENERGY

Review of performance optimization techniques applied to wind turbines

(2015) Adam Chehouri et al.   APPLIED ENERGY

Failure rate, repair time and unscheduled O&M cost analysis of offshore wind turbines

(2015) James Carroll et al.   WIND ENERGY

Special Section on Multidisciplinary Design Optimization: Multidisciplinary Design Optimization of Dynamic Engineering Systems

(2014) James T. Allison et al.   AIAA JOURNAL

Co-Design of an Active Suspension Using Simultaneous Dynamic Optimization

(2014) James T. Allison et al.   JOURNAL OF MECHANICAL DESIGN

Computationally Efficient Combined Plant Design and Controller Optimization Using a Coupling Measure

(2012) Rakesh Patil et al.   JOURNAL OF MECHANICAL DESIGN

Control of Wind Turbines

(2011)   IEEE CONTROL SYSTEMS MAGAZINE