Analysis of microstructure and mechanical properties of additive repaired Ti–6Al–4V by Direct Energy Deposition

Microstructural characterization and comparison of Ti-6Al-4V manufactured with different additive manufacturing processes

(2018) M. Neikter et al.   MATERIALS CHARACTERIZATION

Fatigue life of additively manufactured Ti–6Al–4V in the very high cycle fatigue regime

(2017) J. Günther et al.   INTERNATIONAL JOURNAL OF FATIGUE

Fracture toughness and fatigue crack growth rate properties in wire + arc additive manufactured Ti-6Al-4V

(2016) X Zhang et al.   FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES

Fatigue crack growth behavior and microstructural mechanisms in Ti-6Al-4V manufactured by laser engineered net shaping

(2016) Yuwei Zhai et al.   INTERNATIONAL JOURNAL OF FATIGUE

Fatigue behavior and failure mechanisms of direct laser deposited Ti–6Al–4V

(2016) Amanda J. Sterling et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Influence of microstructure on mechanical properties of laser metal wire-deposited Ti-6Al-4V

(2016) Pia Åkerfeldt et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Anisotropic tensile behavior of Ti–6Al–4V components fabricated with directed energy deposition additive manufacturing

(2015) Beth E. Carroll et al.   ACTA MATERIALIA

Grain morphology evolution behavior of titanium alloy components during laser melting deposition additive manufacturing

(2015) T. Wang et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Effect of microstructure and defects on fatigue behaviour of directed energy deposited Ti–6Al–4V

(2015) A. W. Prabhu et al.   SCIENCE AND TECHNOLOGY OF WELDING AND JOINING

Metal Additive Manufacturing: A Review

(2014) William E. Frazier   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Wire based additive layer manufacturing: Comparison of microstructure and mechanical properties of Ti–6Al–4V components fabricated by laser-beam deposition and shaped metal deposition

(2011) Bernd Baufeld et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Morphology, microstructure, and hardness of titanium (Ti-6Al-4V) blocks deposited by wire-feed additive layer manufacturing (ALM)

(2011) Erhard Brandl et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING