Evaluation of Tensile Properties of Thermally Aged 316LN stainless steel with Varying Nitrogen Content using ABI Technique

High temperature tensile properties of 316LN stainless steel investigated using automated ball indentation technique

(2018) J. Ganesh Kumar et al.   MATERIALS AT HIGH TEMPERATURES

Effects of long-term thermal aging on bulk and local mechanical behavior of ferritic-austenitic duplex stainless steels

(2018) Samuel C. Schwarm et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Round robin exercise on ball indentation technique in India: Indian nuclear reactor materials

(2018) V. Bhasin et al.   NUCLEAR ENGINEERING AND DESIGN

Small specimen test techniques for evaluation of tensile flow properties – Evolution and developmental activities at IGCAR, Kalpakkam

(2018) V. Karthik et al.   NUCLEAR ENGINEERING AND DESIGN

Influence of some Test Parameters on Automated Ball Indentation Test Results

(2017) J. Ganesh Kumar et al.   EXPERIMENTAL TECHNIQUES

Mechanical property degradation and microstructural evolution of cast austenitic stainless steels under short-term thermal aging

(2017) Timothy G. Lach et al.   JOURNAL OF NUCLEAR MATERIALS

Effect of strain rate on low cycle fatigue of 316LN stainless steel with varying nitrogen content: Part-I cyclic deformation behavior

(2015) G.V. Prasad Reddy et al.   INTERNATIONAL JOURNAL OF FATIGUE

Analysis of Intergranular Precipitation in Isothermally Aged Nitrogen-Containing Austenitic Stainless Steels by an Electrochemical Method and Its Relation to Cryogenic Toughness

(2011) Maribel L. Saucedo-Muñoz et al.   Advances in Materials Science and Engineering

Precipitation during aging in N-containing austenitic stainless steels

(2009) Maribel L. Saucedo-Muñoz et al.   MATERIALS CHARACTERIZATION

Recent developments in stainless steels

(2009) K.H. Lo et al.   MATERIALS SCIENCE & ENGINEERING R-REPORTS

Evolution of secondary phases in austenitic stainless steels during long-term exposures at 600, 650 and 800 °C

(2008) Marián Vach et al.   MATERIALS CHARACTERIZATION