Effects of spheroidization heat treatment and intercritical annealing on mechanical properties and corrosion resistance of medium carbon dual phase steel

Influence of phase and interface properties on the stress state dependent fracture initiation behavior in DP steels through computational modeling

(2020) Shipin Qin et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

A comparative study on mechanical behavior and damage scenario of DP600 and DP980 steels

(2020) Ali Cheloee Darabi et al.   MECHANICS OF MATERIALS

A review of recent progress in mechanical and corrosion properties of dual phase steels

(2020) Alireza Kalhor et al.   Archives of Civil and Mechanical Engineering

Transformation-induced plasticity (TRIP) in advanced steels: A review

(2020) Maryam Soleimani et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Comparative Corrosion Behavior of Five Microstructures (Pearlite, Bainite, Spheroidized, Martensite, and Tempered Martensite) Made from a High Carbon Steel

(2019) Prvan Kumar Katiyar et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Synergistic effects of holding time at intercritical annealing temperature and initial microstructure on the mechanical properties of dual phase steel

(2019) Fatemeh Jamei et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Fine tuning the mechanical properties of dual phase steel via thermomechanical processing of cold rolling and intercritical annealing

(2019) Sheida Nikkhah et al.   MATERIALS CHEMISTRY AND PHYSICS

A high-strength heterogeneous structural dual-phase steel

(2019) Bo Gao et al.   JOURNAL OF MATERIALS SCIENCE

Tailoring the microstructure and mechanical properties of AISI 316L austenitic stainless steel via cold rolling and reversion annealing

(2019) Sara Kheiri et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Ferrite recrystallisation and intercritical annealing of cold-rolled low alloy medium carbon steel

(2019) Mohammad Tavakoli et al.   MATERIALS SCIENCE AND TECHNOLOGY

Processing Route Effects on the Mechanical and Corrosion Properties of Dual Phase Steel

(2019) Maryam Soleimani et al.   METALS AND MATERIALS INTERNATIONAL

Unraveling the Effect of Martensite Volume Fraction on the Mechanical and Corrosion Properties of Low‐Carbon Dual‐Phase Steel

(2019) Maryam Soleimani et al.   STEEL RESEARCH INTERNATIONAL

Effects of tempering on the mechanical and corrosion properties of dual phase steel

(2019) Maryam Soleimani et al.   Materials Today Communications

Reversible dislocation movement, martensitic transformation and nano-twinning during elastic cyclic loading of a metastable high entropy alloy

(2019) S.M. Vakili et al.   ACTA MATERIALIA

The critical impact of intercritical deformation on variant pairing of bainite/martensite in dual-phase steels

(2019) M.Y. Sun et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of grain size on the corrosion resistance of low carbon steel

(2019) Maryam Soleimani et al.   Materials Research Express

Flow stress characteristics and design of innovative 3-steps multiphase control thermomechanical processing to produce ultrafine grained bulk steels

(2019) Sumit Ghosh et al.   MATERIALS & DESIGN

Mechanical properties and fracture behavior of intercritically annealed AISI 4130 chromoly steel

(2018) Mehran Zamani et al.   Materials Research Express

Effect of microstructural refinement and intercritical annealing time on mechanical properties of high-formability dual phase steel

(2018) Mahsa Nouroozi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Enhancement of work-hardening behavior of dual phase steel by heat treatment

(2018) Z. Nasiri et al.   MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK

Designing dual-phase steels with improved performance using ANN and GA in tandem

(2018) Tanusree Dutta et al.   COMPUTATIONAL MATERIALS SCIENCE

Effect of microstructure on corrosion behavior of dual-phase steels

(2017) E. SALAMCI et al.   KOVOVE MATERIALY-METALLIC MATERIALS

Examination of phase transformation kinetics during step quenching of dual phase steels

(2017) H. Ashrafi et al.   MATERIALS CHEMISTRY AND PHYSICS

Development of a new dual phase steel with laminated microstructural morphology

(2017) N. Saeidi et al.   MATERIALS CHEMISTRY AND PHYSICS

Abnormal mechanical behavior of a medium-carbon steel under strong ferrite-pearlite-martensite triple-phase microstructures

(2017) A. Sabet Ghorabaei et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Unraveling the Initial Microstructure Effects on Mechanical Properties and Work-Hardening Capacity of Dual-Phase Steel

(2017) Hamed Mirzadeh et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Tempering of Lath Martensite in Low and Medium Carbon Steels: Assessment and Challenges

(2017) George Krauss   STEEL RESEARCH INTERNATIONAL

Electrochemical corrosion behaviors of a stress-aged Al–Zn–Mg–Cu alloy

(2016) Y.C. Lin et al.   JOURNAL OF MATERIALS RESEARCH

Examination and modeling of void growth kinetics in modern high strength dual phase steels during uniaxial tensile deformation

(2016) N. Saeidi et al.   MATERIALS CHEMISTRY AND PHYSICS

Tailoring the Microstructure and Mechanical Properties of Dual Phase Steel Based on the Initial Microstructure

(2016) Alireza Kalhor et al.   STEEL RESEARCH INTERNATIONAL

Alloying effects on microstructure formation of dual phase steels

(2015) L. Schemmann et al.   ACTA MATERIALIA

Effect of Pre-intercritical Annealing Treatments on the Microstructure and Mechanical Properties of 0.33% Carbon Dual-Phase Steel

(2015) Neha Shukla et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Influence of the Initial Microstructure on the Spheroidization of SAE 52100 Bearing Steel

(2015) Hoon Hwang et al.   STEEL RESEARCH INTERNATIONAL

Improvement of mechanical properties in a dual-phase ferrite–martensite AISI4140 steel under tough-strong ferrite formation

(2013) E. Fereiduni et al.   MATERIALS & DESIGN

Microstructure and mechanical properties of spheroidized D6AC steel

(2013) Young-Won Lee et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of cyclic heat treatments on spheroidizing behavior of cementite in high carbon steel

(2013) Z.Q. Lv et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of pre-IC annealing treatments on the final microstructure and work hardening behavior of a dual-phase steel

(2013) H. Seyedrezai et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Subcritical Spheroidization of Medium-Carbon 50CrV4 Steel

(2011) W. Y. Guo et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Spheroidizing Kinetics and Optimization of Heat Treatment Parameters in CK60 Steel Using Taguchi Robust Design

(2010) Ata Kamyabi-Gol et al.   JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL

Mechanical and corrosion behavior of plain low carbon dual-phase steels

(2010) Lakshmana Rao Bhagavathi et al.   MATERIALS & DESIGN

Effect of cyclic heat treatment on microstructure and mechanical properties of 0.6wt% carbon steel

(2010) Atanu Saha et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Influence of martensite morphology on the work-hardening behavior of high strength ferrite–martensite dual-phase steel

(2009) Debdulal Das et al.   JOURNAL OF MATERIALS SCIENCE

Electrochemical corrosion response of a low carbon heat treated steel in a NaCl solution

(2009) W. R. Osório et al.   MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION

Effect of various dual-phase heat treatments on the corrosion behavior of reinforcing steel used in the reinforced concrete structures

(2008) Oğuzhan Keleştemur et al.   CONSTRUCTION AND BUILDING MATERIALS

The Cementite Spheroidization Process in High-Carbon Steels with Different Chromium Contents

(2008) N.V. Luzginova et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Influence of different initial microstructure on the process of spheroidization in cold forging

(2007) Erdal Karadeniz   MATERIALS & DESIGN