Voxel-based finite element modelling of wood elements based on spatial density and geometry data using computed tomography

Analysis of Flow Patterns in High-Gravity Equipment Using Gamma-Ray Computed Tomography

(2019) Kai Groß et al.   CHEMIE INGENIEUR TECHNIK

Profitability gain expectations for computed tomography of sawn logs

(2019) Martin Pernkopf et al.   European Journal of Wood and Wood Products

Structural behaviour of hardwood veneer-based circular hollow sections of different compactness

(2018) Benoit P. Gilbert et al.   CONSTRUCTION AND BUILDING MATERIALS

Hygro-mechanical investigations of clavichord replica at cyclic climate load: Experiments and simulations

(2018) Daniel Konopka et al.   JOURNAL OF CULTURAL HERITAGE

Density profile and microstructural analysis of densified beech wood (Fagus sylvatica L.) plasticized by microwave treatment

(2017) Jakub Dömény et al.   European Journal of Wood and Wood Products

Experimental and theoretical investigations on moulded wooden tubes made of beech ( Fagus sylvatica L.)

(2016) Jens U. Hartig et al.   CONSTRUCTION AND BUILDING MATERIALS

An Experimental Study on the Gas Entrainment in Horizontally and Vertically Installed Centrifugal Pumps

(2016) Martin Neumann et al.   JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME

Fast and flexible X-ray tomography using the ASTRA toolbox

(2016) Wim van Aarle et al.   OPTICS EXPRESS

Compressed and moulded wood from processing to products

(2015) Andreja Kutnar et al.   HOLZFORSCHUNG

The ASTRA Toolbox: A platform for advanced algorithm development in electron tomography

(2015) Wim van Aarle et al.   ULTRAMICROSCOPY

Microfibril Angle: Measurement, Variation and Relationships – A Review

(2013) Lloyd Donaldson   IAWA JOURNAL

Water and n-Heptane Volume Fractions in a Rotor-Stator Spinning Disc Reactor

(2012) Frans Visscher et al.   INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH

Moisture-dependent elastic and strength anisotropy of European beech wood in tension

(2012) Tomasz Ozyhar et al.   JOURNAL OF MATERIALS SCIENCE

Tomography measurements of gas holdup in rotating foam reactors with Newtonian, non-Newtonian and foaming liquids

(2011) R. Tschentscher et al.   CHEMICAL ENGINEERING SCIENCE

Advanced Tomographic Techniques for Flow Imaging in Columns with Flow Distribution Packings

(2011) Markus Schubert et al.   CHEMIE INGENIEUR TECHNIK

Performance improvements for iterative electron tomography reconstruction using graphics processing units (GPUs)

(2011) W.J. Palenstijn et al.   JOURNAL OF STRUCTURAL BIOLOGY

Temperature control design for a high-resolution gamma-ray tomography detector

(2010) André Bieberle et al.   REVIEW OF SCIENTIFIC INSTRUMENTS

Full Three-Dimensional Strain Measurements on Wood Exposed to Three-Point Bending: Analysis by Use of Digital Volume Correlation Applied to Synchrotron Radiation Micro-Computed Tomography Image Data

(2010) F. Forsberg et al.   STRAIN

Fiber-Reinforced Plastic-Confined Wood Profiles Under Axial Compression

(2010) Andreas Heiduschke et al.   Structural Engineering International

3D micro-scale deformations of wood in bending: Synchrotron radiation μCT data analyzed with digital volume correlation

(2008) F. Forsberg et al.   JOURNAL OF STRUCTURAL BIOLOGY

The effect of out-of-plane motion on 2D and 3D digital image correlation measurements

(2008) M.A. Sutton et al.   OPTICS AND LASERS IN ENGINEERING