Effect of annealing temperature on the microstructure evolution, mechanical and wear behavior of NiCr–WC–Co HVOF-sprayed coatings

Experimental phase diagram, thermodynamic modeling and solidified microstructure in the Mo–Ni–W ternary system

(2020) Meifang Tang et al.   CALPHAD-COMPUTER COUPLING OF PHASE DIAGRAMS AND THERMOCHEMISTRY

Self-healing ceramic coatings that operate in extreme environments: A review

(2020) Samir M. Aouadi et al.   JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A

The elevated-temperature wear behavior evolution of HVOF sprayed tungsten carbide coatings: Respond to heat treatment

(2018) Teng Wang et al.   INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS

Investigation of WC decarburization effect on the microstructure and wear behavior of WC-Ni hardfacing under dry and alkaline wet conditions

(2018) Billel Cheniti et al.   MATERIALS CHEMISTRY AND PHYSICS

Room and elevated temperature sliding wear behavior of cold sprayed Ni-WC composite coatings

(2018) T.B. Torgerson et al.   SURFACE & COATINGS TECHNOLOGY

Dry sliding wear behaviour of cold-sprayed Cu-MoS 2 and Cu-MoS 2 -WC composite coatings: The influence of WC

(2018) Yinyin Zhang et al.   TRIBOLOGY INTERNATIONAL

Investigation on annealing strengthening effect of laser cladding Fe5Cr5Co5SiTiNbMoW high-entropy alloy coating

(2018) Yaxiong Guo et al.   JOURNAL OF MATERIALS RESEARCH

Effect of Cr and Mn addition and heat treatment on AlSi3Mg casting alloy

(2017) Marialaura Tocci et al.   MATERIALS CHARACTERIZATION

Effects of microstructure and heat treatment on mechanical properties and corrosion behavior of powder metallurgy derived Fe–30Mn alloy

(2017) Mahdi Dehestani et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Tribological properties of HVOF-sprayed WC-Co coatings deposited from Ni-plated powders at elevated temperature

(2017) Majid Jafari et al.   SURFACE & COATINGS TECHNOLOGY

Effect of heat treatment on structure and property evolutions of atmospheric plasma sprayed NiCrBSi coatings

(2017) Liming Liu et al.   SURFACE & COATINGS TECHNOLOGY

Comparison of tribological properties of HVOF sprayed coatings with different composition

(2017) Abdullah Cahit Karaoglanli et al.   SURFACE & COATINGS TECHNOLOGY

Wear behavior of HVOF sprayed WC coating under water-in-oil fracturing fluid condition

(2017) Chao Zheng et al.   TRIBOLOGY INTERNATIONAL

New perspectives in hardmetal abrasion simulation

(2017) A.J. Gant et al.   WEAR

Influence of heat treatment on the strength and fracture toughness of 7N01 aluminum alloy

(2016) Bo Li et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Influence of heat treatment on the abrasive wear resistance of a Cr3C2NiCr coating deposited by an ethene-fuelled HVOF spray process

(2016) Leo Janka et al.   SURFACE & COATINGS TECHNOLOGY

Effects of heat treatment on microstructure and mechanical properties of Ni60/h-BN self-lubricating anti-wear composite coatings on 304 stainless steel by laser cladding

(2015) Xiao-Long Lu et al.   APPLIED SURFACE SCIENCE

Effect of Heat Treatment on the Microstructure and Properties of HVOF-Sprayed Co-Cr-W Coating

(2015) Šárka Houdková et al.   JOURNAL OF THERMAL SPRAY TECHNOLOGY

Hypereutectoid steel coatings obtained by thermal flame spraying — Effect of annealing on microstructure, tribological properties and adhesion energy

(2015) Abdelatif Belamri et al.   SURFACE & COATINGS TECHNOLOGY

Effect of sequential turning and burnishing on the surface integrity of Cr–Ni-based stainless steel formed by laser cladding process

(2015) Peirong Zhang et al.   SURFACE & COATINGS TECHNOLOGY

Wear behaviour of WC–Co HVOF coatings at different temperatures in air and argon

(2015) Z. Geng et al.   WEAR

Effect of high-temperature furnace treatment on the microstructure and corrosion behavior of NiCrBSi flame-sprayed coatings

(2014) Zoran Bergant et al.   CORROSION SCIENCE

Properties of NiCrBSi coating, as sprayed and remelted by different technologies

(2014) Šárka Houdková et al.   SURFACE & COATINGS TECHNOLOGY

Determination of Interfacial Fracture Toughness of Thermal Spray Coatings by Indentation

(2013) Yasuhiro Yamazaki et al.   JOURNAL OF THERMAL SPRAY TECHNOLOGY

Microstructure and wear behaviors of laser clad NiCr/Cr3C2–WS2 high temperature self-lubricating wear-resistant composite coating

(2011) Mao-Sheng Yang et al.   APPLIED SURFACE SCIENCE

Microstructures and abrasive wear performance of PTAW deposited Ni–WC overlays using different Ni-alloy chemistries

(2011) T. Liyanage et al.   WEAR

Characterisation of HVOF sprayed Cr3C2-50(Ni20Cr) coating and the influence of binder properties on solid particle erosion behaviour

(2010) J.K.N. Murthy et al.   SURFACE & COATINGS TECHNOLOGY

Quality Improvement of Flame Sprayed, Heat Treated, and Remelted NiCrBSi Coatings

(2009) Z. Bergant et al.   JOURNAL OF THERMAL SPRAY TECHNOLOGY

Analysis of crack behavior for Ni-based WC composite coatings by laser cladding and crack-free realization

(2008) Shengfeng Zhou et al.   APPLIED SURFACE SCIENCE

The interfacial indentation test to determine adhesion and residual stresses in NiCr VPS coatings

(2008) G. Marot et al.   SURFACE & COATINGS TECHNOLOGY

Influence of HVOF parameters on the corrosion and wear resistance of WC-Co coatings sprayed on AA7050 T7

(2008) M. Magnani et al.   SURFACE & COATINGS TECHNOLOGY