Effect of Sc Content on the Microstructure and Properties of Al–Mg–Sc Alloys Deposited by Wire Arc Additive Manufacturing

Superior Strength with Enhanced Fracture Resistance of Al-Mg-Sc Alloy Through Two-Step Cryo Cross Rolling

(2019) S. Vigneshwaran et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Effect of Mg Content on Microstructure and Properties of Al–Mg Alloy Produced by the Wire Arc Additive Manufacturing Method

(2019) Lingling Ren et al.   Materials

Additive manufacturing using WAAM with AA5183 wire

(2018) A. Horgar et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

A review of wire arc additive manufacturing and advances in wire arc additive manufacturing of aluminium

(2018) K. S. Derekar   MATERIALS SCIENCE AND TECHNOLOGY

Influence of the degree of scandium supersaturation on the precipitation kinetics of rapidly solidified Al-Mg-Sc-Zr alloys

(2016) J. Taendl et al.   ACTA MATERIALIA

Geometric Limitation and Tensile Properties of Wire and Arc Additive Manufacturing 5A06 Aluminum Alloy Parts

(2016) Haibin Geng et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

The strengthening effect of inter-layer cold working and post-deposition heat treatment on the additively manufactured Al–6.3Cu alloy

(2016) Jianglong Gu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

A comparative study of additive manufacturing techniques: Residual stress and microstructural analysis of CLAD and WAAM printed Ti–6Al–4V components

(2016) Blanka A. Szost et al.   MATERIALS & DESIGN

Effect of arc mode in cold metal transfer process on porosity of additively manufactured Al-6.3%Cu alloy

(2014) Baoqiang Cong et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Effect of local volume fraction of microporosity on tensile properties in Al–Si–Mg cast alloy

(2010) M. Kobayashi et al.   MATERIALS SCIENCE AND TECHNOLOGY