Optimized Thermomechanical Processing for Fine-Grained Dual-Phase Microstructure Using Deformation-Induced Ferrite Transformation

Hot deformation characteristics and dislocation substructure evolution of a nickel-base alloy considering effects of δ phase

(2018) Dong-Xu Wen et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Microstructural evolution of a Ni-Fe-Cr-base superalloy during non-isothermal two-stage hot deformation

(2018) Y.C. Lin et al.   VACUUM

Effects of temperature and strain rate on the dynamic recrystallization of a medium-high-carbon high-silicon bainitic steel during hot deformation

(2018) Ying Han et al.   VACUUM

Dynamic Recrystallization and Grain Refinement of Fe-P-C-Si and Fe-P-C-Si-N Steels

(2018) Yashwant Mehta et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Exploring the influence of Al content on the hot deformation behavior of Fe-Mn-Al-C steels through 3D processing map

(2018) Zhiqiang Wu et al.   VACUUM

Modelling of Flow Stress and Prediction of Workability by Processing Map for Hot Compression of 43CrNi Steel

(2017) Niranjan Kumar et al.   ISIJ INTERNATIONAL

Characterization of hot deformation behavior of a low carbon steel using processing maps, constitutive equations and Zener-Hollomon parameter

(2016) S.K. Rajput et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

EBSD analysis of evolution of dynamic recrystallization grains and δ phase in a nickel-based superalloy during hot compressive deformation

(2016) Y.C. Lin et al.   MATERIALS & DESIGN

Physical Simulation of Hot Deformation of Low-Carbon Ti-Nb Microalloyed Steel and Microstructural Studies

(2014) S. K. Rajput et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Physical simulation of hot deformation and microstructural evolution of AISI 1016 steel using processing maps

(2013) S.K. Rajput et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Flow stress analysis for determining the critical condition of dynamic ferrite transformation in 6Ni–0.1C steel

(2012) Nokeun Park et al.   ACTA MATERIALIA

Mechanisms of void formation during tensile testing in a commercial, dual-phase steel

(2011) J. Kadkhodapour et al.   ACTA MATERIALIA

Deformation and fracture mechanisms in fine- and ultrafine-grained ferrite/martensite dual-phase steels and the effect of aging

(2010) Marion Calcagnotto et al.   ACTA MATERIALIA

The effect of intercritical heat treatment temperature on the tensile properties and work hardening behavior of ferrite–martensite dual phase steel sheets

(2009) P. Movahed et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Grain Refinement in Dual-Phase Steels

(2009) K. Mukherjee et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE