The Effect of Printing Parameters on Electrical Conductivity and Mechanical Properties of PLA and ABS Based Carbon Composites in Additive Manufacturing of Upper Limb Prosthetics

Novel PLA-CaCO3 composites in additive manufacturing of upper limb casts and orthotics – A feasibility study

(2019) Péter Varga et al.   Materials Research Express

Characterization of the Mechanical Properties of FFF Structures and Materials: A Review on the Experimental, Computational and Theoretical Approaches

(2019) Enrique Cuan-Urquizo et al.   Materials

Flexure Behaviors of ABS-based Composites Containing Carbon and Kevlar Fibers by Material Extrusion 3D Printing

(2019) Wang et al.   Polymers

Additive manufacturing (3D printing): A review of materials, methods, applications and challenges

(2018) Tuan D. Ngo et al.   COMPOSITES PART B-ENGINEERING

3D printed upper limb prosthetics

(2018) Ivan Vujaklija et al.   Expert Review of Medical Devices

PLA conductive filament for 3D printed smart sensing applications

(2018) Simone Luigi Marasso et al.   RAPID PROTOTYPING JOURNAL

The Influence of Manufacturing Parameters on the Mechanical Behaviour of PLA and ABS Pieces Manufactured by FDM: A Comparative Analysis

(2018) Adrián Rodríguez-Panes et al.   Materials

Printing orientation defines anisotropic mechanical properties in additive manufacturing of upper limb prosthetics

(2018) Peter Maroti et al.   Materials Research Express

Effect of build orientation on the mechanical reliability of 3D printed ABS

(2017) Özgür Keleş et al.   RAPID PROTOTYPING JOURNAL

Mechanical and thermal properties of ABS/montmorillonite nanocomposites for fused deposition modeling 3D printing

(2016) Zixiang Weng et al.   MATERIALS & DESIGN

Three-Dimensional Printing of High-Content Graphene Scaffolds for Electronic and Biomedical Applications

(2015) Adam E. Jakus et al.   ACS Nano

3D Printing for the Rapid Prototyping of Structural Electronics

(2014) Eric Macdonald et al.   IEEE Access

Epidemiology of Limb Loss

(2013) Priya Varma et al.   Physical Medicine and Rehabilitation Clinics of North America

A Simple, Low-Cost Conductive Composite Material for 3D Printing of Electronic Sensors

(2012) Simon J. Leigh et al.   PLoS One

Rapid prototyping of electrically conductive components using 3D printing technology

(2009) J. Czyżewski et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Estimating the Prevalence of Limb Loss in the United States: 2005 to 2050

(2008) Kathryn Ziegler-Graham et al.   ARCHIVES OF PHYSICAL MEDICINE AND REHABILITATION