4.8 Article

Functional Janus-SiO2 Nanoparticles Prepared by a Novel Cut the Gordian Knot Method and Their Potential Application for Enhanced Oil Recovery

Journal

ACS APPLIED MATERIALS & INTERFACES
Volume 12, Issue 21, Pages 24201-24208

Publisher

AMER CHEMICAL SOC
DOI: 10.1021/acsami.0c01593

Keywords

Janus-SiO2; interface protection; chemical etching; bidirectional regulation; enhanced oil recovery

Funding

  1. National Natural Science Foundation of China [21571188, 21371047]
  2. Science and Technology Project of Henan Province [192102210203, 181100310600]
  3. Jiangsu Planned Projects for Postdoctoral Research Funds of China [7131712019]

Ask authors/readers for more resources

Currently available methods (e.g., interfacial protection and phase separation) for preparing Janus nanoparticles are often complex and expensive. Furthermore, the preparation of Janus nanoparticles with a particle size below 10 nm is challenging. In this work, we combine an in situ surface-modification route with a chemical etching route to establish a novel cut the Gordian knot method for the preparation of functional Janus-SiO2 nanoparticles. Hydrophobic SiO2 nanoparticles with a three-dimensional network structure prepared via an in situ surface-modification route were dispersed in NaOH solution containing surfactant or ethanol to enable corrosion close to the modifier-nanoparticle interface with a relatively low content of surface modifiers. Thus, amphipathic Janus-SiO2 nanoparticles with a hydrophilic surface containing Si-OH species and a hydrophobic surface containing -CH3 fragments were generated. The as-prepared Janus-SiO2 nanoparticles with a size of 4-9 nm and a specific surface area of up to 612.9 m(2)/g can be easily dispersed in water, and they also can transfer from the water phase to the oil phase by tuning the surface polarity. Moreover, they can be tuned to achieve bidirectional regulation of surface wettability plus a reduction of the oil/water interface tension. Hence, a significant reduction (by 33 similar to 50%) of water injection pressure and an enhanced oil recovery (EOR) (by 21.1% similar to 26.6%) can be achieved. Apart from that, Janus-SiO2 nanoparticles are able to increase the viscosity of partially hydrolyzed polyacrylamide by 282.9% and significantly decrease its viscosity loss ratio in brine, causing an EOR of about 36.6%. With simple, low-cost, and scalable procedures, the following approach could be well applicable to fabricating Janus-SiO2 nanoparticles with a high potential for augmented water injection as well as EOR of low-permeability reservoirs.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available