Enhancing adhesive joints between commercial rubber (SBS) and polyurethane by low-pressure plasma surface modification

The paper presents research on the two-stage process of low-pressure plasma surface modification of a commercial SBS rubber, improving its adhesion to both the polyurethane adhesive in an organic solvent (PU) and the aqueous polyurethane adhesive dispersion (ADPU). The plasma surface modification process was carried out in a flow reactor with parallel plate electrodes, in which plasma was generated by an RF glow discharge (13.56 MHz), In the first stage of the process, the Ar or O-2 plasma was used, and then, as the second stage of the modification process, the treatment was performed in H2O plasma. The adhesive properties of the plasma-modified SBS rubber surface were determined using the 180 degrees-peel strength test (PS). These results were correlated with surface properties investigated using contact angle (CA) measurements, FTIR-ATR spectroscopy, XPS spectroscopy and scanning electron microscopy (SEM). The observed improvement in wettability of the plasma modified surface was attributed to the formation of hydroxyl groups, which was confirmed by spectroscopic methods (FTiR-ATR and XPS). The results of the 180 degrees-peel strength test showed, in turn, a clear relationship between the capacity of adhesive bonding and the amount of oxygen groups (mainly the hydroxyl groups) as well as the surface roughness, determined by SEM microscopy. It was also found that the effects of the plasma surface modification of the SBS rubber were stable for at least 72 h. The results of this work prove that cleaning and etching of the commercial SBS rubber surface in the first stage of its plasma treatment, followed by chemical modification in the second stage, lead to very strong adhesive joints.