Stabilization of a turbulent premixed flame by a plasma filament

The mechanism of stabilizing a turbulent premixed methane-air flame using warm filamentary plasma is investigated by using laser diagnostics. First, stabilization of a turbulent jet flame is demonstrated in a setup using a pin-to-pin plasma discharge. The coupled plasma-flame structures were visualized utilizing planar laser-induced fluorescence (PLIF) of formaldehyde (CH2O) and methylidyne radicals (CH), as well as laser Rayleigh scattering thermometry imaging. The results show that the plasma channel and the flame front are spatially separated by a layer of hot burning products attributed to the flame propagation from the plasma core. Because of this spatial separation, the impacts of plasma on combustion are primarily thermal since the energetic radical species (such as O, H), produced by the discharge, have short equilibration time and cannot spread far away from the discharge channel before reaching the equilibrium state. From this point of view, turbulence would be beneficial for promoting the transport of plasma-produced radicals and thus bridge the gap between the plasma and the flame front. The plasma is still able to stabilize the flame. Based upon the experimental results, a frequent ignition-flame propagation (FIFP) model is proposed to explain the flame stabilization process. For the contracted plasma filament, the local power density is high enough to initialize the flame kernel that propagates away from the plasma channel until extinction. The propagation process is, however, strongly affected by turbulence. Local extinction is highly probable and thus the flame front has to be close to the ignition source at strong turbulence. At such conditions, the stabilized flame can be regarded as a large number of flame pockets, repeating the three phases of ignition, propagation and extinction, which can be summarized as the FIFP model. It infers that the flame propagation phase is important for sustaining the flame to complete combustion. Hence, this phase should be extended, which is more probable to achieve if the plasma ignition pilot is located in a section of limited turbulence. (C) 2019 The Authors. Published by Elsevier Inc.