Effect of Heating Rate during Continuous Annealing on Microstructure and Mechanical Properties of High-Strength Dual-Phase Steel

Effect of holding time at an intercritical temperature on the microstructure and tensile properties of a ferrite-martensite dual phase steel

(2018) M. Balbi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Refinement of Banded Structure via Thermal Cycling and Its Effects on Mechanical Properties of Dual Phase Steel

(2018) Sajad Ghaemifar et al.   STEEL RESEARCH INTERNATIONAL

Enhancement of mechanical properties of low carbon dual phase steel via natural aging

(2018) Mehran Zamani et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of microstructural refinement and intercritical annealing time on mechanical properties of high-formability dual phase steel

(2018) Mahsa Nouroozi et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

High Strength-High Ductility Combination Ultrafine-Grained Dual-Phase Steels Through Introduction of High Degree of Strain at Room Temperature Followed by Ultrarapid Heating During Continuous Annealing of a Nb-Microalloyed Steel

(2017) Yonggang Deng et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Effect of Intercritical Annealing on Mechanical Properties and Work-Hardening Response of High Formability Dual Phase Steel

(2017) Mehdi Maleki et al.   STEEL RESEARCH INTERNATIONAL

Development of a high strength and ductile Nb-bearing dual phase steel by cold-rolling and intercritical annealing of the ferrite-martensite microstructures

(2016) Ali Ghatei Kalashami et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of martensite morphology and volume fraction on strain hardening and fracture behavior of martensite–ferrite dual phase steel

(2015) Jiecen Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of heating rate on nucleation and growth of austenite in cold rolled dual phase steel

(2014) P. Li et al.   IRONMAKING & STEELMAKING

Effect of heating rate on ferrite recrystallization and austenite formation of cold-roll dual phase steel

(2013) Pei Li et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Galvanizing and Galvannealing Behavior of CMnSiCr Dual-Phase Steels

(2013) Ko-Chun Lin et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Dual phase structure formed by partial reversion of cold-deformed martensite

(2012) Nobuo Nakada et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Formation of Ultrafine Grained Dual Phase Steels through Rapid Heating

(2011) Hamid Azizi-Alizamini et al.   ISIJ INTERNATIONAL

Effect of Heating Rate on the Austenite Formation in Low-Carbon High-Strength Steels Annealed in the Intercritical Region

(2011) R. R. Mohanty et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Deformation and fracture mechanisms in fine- and ultrafine-grained ferrite/martensite dual-phase steels and the effect of aging

(2010) Marion Calcagnotto et al.   ACTA MATERIALIA

Influence of martensite morphology on the work-hardening behavior of high strength ferrite–martensite dual-phase steel

(2009) Debdulal Das et al.   JOURNAL OF MATERIALS SCIENCE

Toughness deterioration in advanced high strength bainitic steels

(2009) F.G. Caballero et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Strain Hardening Behavior of Dual-Phase Steels

(2009) V. Colla et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE