Alternative Process Routes to Manufacture Porous Ceramics—Opportunities and Challenges

Numerical and experimental evaluation and optimization of ceramic foam as solar absorber – Single-layer vs multi-layer configurations

(2018) Fritz Zaversky et al.   APPLIED ENERGY

Investigation of Droplet Deposition for Suspensions Usable for Thermoplastic 3D Printing (T3DP)

(2017) Uwe Scheithauer et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Additive Manufacturing of Ceramic Heat Exchanger: Opportunities and Limits of the Lithography-Based Ceramic Manufacturing (LCM)

(2017) Uwe Scheithauer et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Characteristics of a Continuous Direct Foaming Technique

(2015) Fabian Luthardt et al.   International Journal of Applied Ceramic Technology

Washcoat Deposition of Ni- and Co-ZrO2 Low Surface Area Powders onto Ceramic Open-Cell Foams: Influence of Slurry Formulation and Rheology

(2015) Riccardo Balzarotti et al.   Catalysts

Processing and properties of advanced porous ceramics: An application based review

(2014) E.C. Hammel et al.   CERAMICS INTERNATIONAL

Macroporous ceramics: Novel route using partial sintering of alumina-powder agglomerates obtained by spray-drying

(2014) Guillaume Jean et al.   CERAMICS INTERNATIONAL

Thermoplastic 3D Printing-An Additive Manufacturing Method for Producing Dense Ceramics

(2014) Uwe Scheithauer et al.   International Journal of Applied Ceramic Technology

Additive Manufacturing of Dense Alumina Ceramics

(2014) Martin Schwentenwein et al.   International Journal of Applied Ceramic Technology

Studies on thermoplastic 3D printing of steel–zirconia composites

(2014) Uwe Scheithauer et al.   JOURNAL OF MATERIALS RESEARCH

Functionalization of open-celled foams by homogeneous slurry based coatings

(2013) Daniela Boettge et al.   JOURNAL OF MATERIALS RESEARCH

Relationship between Rheological Behaviour and Final Structure ofAl2O3and YSZ Foams Produced by Replica

(2012) S. Y. Gómez et al.   Advances in Materials Science and Engineering

Cellular Ceramics in Combustion Environments

(2011) Alexander Füssel et al.   ADVANCED ENGINEERING MATERIALS