A comparative study on the evolution of microstructure and hardness during monotonic and cyclic high pressure torsion of CoCuFeMnNi high entropy alloy

Influence of severe straining and strain rate on the evolution of dislocation structures during micro-/nanoindentation in high entropy lamellar eutectics

(2018) T. Maity et al.   INTERNATIONAL JOURNAL OF PLASTICITY

Phase equilibria in equiatomic CoCuFeMnNi high entropy alloy

(2018) Reshma Sonkusare et al.   MATERIALS CHEMISTRY AND PHYSICS

High-entropy alloys and metallic nanocomposites: Processing challenges, microstructure development and property enhancement

(2018) Amit S. Sharma et al.   MATERIALS SCIENCE & ENGINEERING R-REPORTS

Effect of Ti on phase stability and strengthening mechanisms of a nanocrystalline CoCrFeMnNi high-entropy alloy

(2018) Hamed Shahmir et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructure and Mechanical Properties of High-Entropy Alloy Co20Cr26Fe20Mn20Ni14 Processed by High-Pressure Torsion at 77 K and 300 K

(2018) Jongun Moon et al.   Scientific Reports

Understanding the deformation behavior of CoCuFeMnNi high entropy alloy by investigating mechanical properties of binary ternary and quaternary alloy subsets

(2018) Rani Agarwal et al.   MATERIALS & DESIGN

In the quest of single phase multi-component multiprincipal high entropy alloys

(2017) Tazuddin et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Cyclically induced grain growth within shear bands investigated in UFG Ni by cyclic high pressure torsion

(2017) Marlene Walpurga Kapp et al.   JOURNAL OF MATERIALS RESEARCH

Powder metallurgical processing of equiatomic AlCoCrFeNi high entropy alloy: Microstructure and mechanical properties

(2017) S. Mohanty et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Atomic-scale homogenization in an fcc-based high-entropy alloy via severe plastic deformation

(2016) Hao Yuan et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Anomalies in the deformation mechanism and kinetics of coarse-grained high entropy alloy

(2016) Mageshwari Komarasamy et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Deciphering micro-mechanisms of plastic deformation in a novel single phase fcc-based MnFeCoNiCu high entropy alloy using crystallographic texture

(2016) Tazuddin et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effects of high pressure torsion on microstructures and properties of an Al 0.1 CoCrFeNi high-entropy alloy

(2016) P.F. Yu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Ab initio thermodynamics of the CoCrFeMnNi high entropy alloy: Importance of entropy contributions beyond the configurational one

(2015) Duancheng Ma et al.   ACTA MATERIALIA

Mechanical properties, microstructure and thermal stability of a nanocrystalline CoCrFeMnNi high-entropy alloy after severe plastic deformation

(2015) B. Schuh et al.   ACTA MATERIALIA

Hardening of an Al0.3CoCrFeNi high entropy alloy via high-pressure torsion and thermal annealing

(2015) Q.H. Tang et al.   MATERIALS LETTERS

Lattice strain framework for plastic deformation in complex concentrated alloys including high entropy alloys

(2015) R. S. Mishra et al.   MATERIALS SCIENCE AND TECHNOLOGY

Continuous dynamic recrystallization during severe plastic deformation

(2015) Mattia Bacca et al.   MECHANICS OF MATERIALS

Direct evidence for grain boundary motion as the dominant restoration mechanism in the steady-state regime of extremely cold-rolled copper

(2014) O. Renk et al.   ACTA MATERIALIA

Sinter ageing of equiatomic Al20Co20Cu20Zn20Ni20 high entropy alloy via mechanical alloying

(2014) Sutanuka Mohanty et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Observation of a New Mechanism Balancing Hardening and Softening in Metals

(2014) Tianbo Yu et al.   Materials Research Letters

Twenty-five years of ultrafine-grained materials: Achieving exceptional properties through grain refinement

(2013) Terence G. Langdon   ACTA MATERIALIA

Processing and Consolidation of Nanocrystalline Cu-Zn-Ti-Fe-Cr High-Entropy Alloys via Mechanical Alloying

(2013) Sanghita Mridha et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Texture and Microstructural Evolution in Pearlitic Steel During Triaxial Compression

(2012) Pankaj Kumar et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Solidification Behaviour of Ti–Cu–Fe–Co–Ni High Entropy Alloys

(2012) Ajit Kumar Mishra et al.   TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS

Effect of strain path change on the evolution of texture and microstructure during rolling of copper and nickel

(2011) N.P. Gurao et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Evolution of sub-micron grain size and weak texture in magnesium alloy Mg–3Al–0.4Mn by a modified multi-axial forging process

(2011) Somjeet Biswas et al.   SCRIPTA MATERIALIA

Saturation of Fragmentation During Severe Plastic Deformation

(2010) R. Pippan et al.   Annual Review of Materials Research

Technical parameters affecting grain refinement by high pressure torsion

(2010) Anton Hohenwarter et al.   International Journal of Materials Research

Significance of strain reversals in a two-phase alloy processed by high-pressure torsion

(2010) Megumi Kawasaki et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of Mg addition on strengthening of aluminium alloys subjected to different strain paths in high pressure torsion

(2010) Jiuwen Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Microstructure development and hardening during high pressure torsion of commercially pure aluminium: Strain reversal experiments and a dislocation based model

(2010) Jiuwen Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Modeling of continuous dynamic recrystallization in commercial-purity aluminum

(2009) Håkan Hallberg et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Hardening and Softening Behavior by Cyclic High-Pressure Torsion

(2009) F. Wetscher et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

The significance of strain reversals during processing by high-pressure torsion

(2008) Megumi Kawasaki et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING