Response of ytterbium disilicate-silicon environmental barrier coatings to thermal cycling in water vapor

A preliminary study of a promising bi-layer environmental barrier coating (EBC) designed to reduce the susceptibility of SiC composites to hot water vapor erosion is reported. The EBC system consisted of a silicon bond coat and a pore-free ytterbium disilicate (YbDS; Yb2Si2O7) topcoat. Both layers were deposited on alpha-SiC substrates using a recently optimized air plasma spray method. The two layers of the coating system had coefficients of thermal expansion (CTE) that were well matched to that of the substrate, while the YbDS has been reported to have a moderate resistance to silicon hydroxide vapor forming reactions in water vapor rich environments. Thermal cycling experiments were conducted between 110 degrees C and 1316 degrees C in a flowing 90% H2O/10% O-2 atmospheric pressure environment, and resulted in the formation of a thermally grown (silica) oxide (TGO) at the silicon-ytterbium disilicate interface. The TGO layer exhibited linear oxidation kinetics consistent with oxidizer diffusion through the ytterbium silicate layer controlling its thickening rate. The effective diffusion coefficient of the oxidizing species in the YbDS layer was estimated to be 2 x 10(-12) m(2)s(-1) at 1316 degrees C. Slow steam volatilization of the YbDS topcoat resulted in the formation of a thin, partially protective, high CTE ytterbium monosilicate layer on the outside of the YbDS coating. Progressive edge delamination of the coating system was observed with steam exposure time, consistent with water vapor volatilization of the TGO edges that were directly exposed to the environment. This was aided by outward bending of the delaminated region to relax TGO and YbMS surface layer stresses developed during the cooling phase of each thermal cycle. (C) 2016 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.