From Powders to Dense Metal Parts: Characterization of a Commercial AlSiMg Alloy Processed through Direct Metal Laser Sintering

Economics of additive manufacturing for end-usable metal parts

(2012) Eleonora Atzeni et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Influence of process parameters on surface roughness of aluminum parts produced by DMLS

(2012) F. Calignano et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Laser sintering of blended Al‐Si powders

(2012) Eyitayo Olatunde Olakanmi et al.   RAPID PROTOTYPING JOURNAL

Additive manufactured AlSi10Mg samples using Selective Laser Melting (SLM): Microstructure, high cycle fatigue, and fracture behavior

(2011) Erhard Brandl et al.   MATERIALS & DESIGN

Study of mechanical properties of AISI 316 stainless steel processed by “selective laser melting”, following different manufacturing strategies

(2010) Itziar Tolosa et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Densification mechanism and microstructural evolution in selective laser sintering of Al–12Si powders

(2010) E.O. Olakanmi et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Influence of size and volume fraction of SiC particulates on properties of ex situ reinforced Al–4.5Cu–3Mg metal matrix composite prepared by direct metal laser sintering process

(2010) Subrata Kumar Ghosh et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Direct metal laser fabrication: machine development and experimental work

(2009) Jialin Yang et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Composites by rapid prototyping technology

(2009) S. Kumar et al.   MATERIALS & DESIGN

Effect of SiC particles on the laser sintering of Al–7Si–0.3Mg alloy

(2008) A. Simchi et al.   SCRIPTA MATERIALIA