Third Body Behavior During Dry Sliding of Cold-Sprayed Al-Al2O3 Composites: In Situ Tribometry and Microanalysis

Materials Phenomena Revealed by In Situ Tribometry

(2012) R. R. Chromik et al.   JOM

In situ tribometry of cold-sprayed Al-Al2O3 composite coatings

(2012) J.M. Shockley et al.   SURFACE & COATINGS TECHNOLOGY

Severe wear of a near eutectic aluminium–silicon alloy

(2011) Anirban Mahato et al.   ACTA MATERIALIA

Inhomogeneous microstructural evolution of pure iron during high-pressure torsion

(2011) S. Descartes et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

In situ tribology of nanocomposite Ti–Si–C–H coatings prepared by PE-CVD

(2011) Holger W. Strauss et al.   WEAR

Scaling effects between micro- and macro-tribology for a Ti–MoS2 coating

(2011) Pantcho Stoyanov et al.   WEAR

Correlation between dislocation density and pop-in phenomena in aluminum studied by nanoindentation and electron channeling contrast imaging

(2010) Afrooz Barnoush et al.   SCRIPTA MATERIALIA

Effect of α-Al2O3 on the properties of cold sprayed Al/α-Al2O3 composite coatings on AZ91D magnesium alloy

(2009) Yongshan Tao et al.   APPLIED SURFACE SCIENCE

The use of Al–Al2O3 cold spray coatings to improve the surface properties of magnesium alloys

(2009) K. Spencer et al.   SURFACE & COATINGS TECHNOLOGY

Review on Cold Spray Process and Technology: Part I—Intellectual Property

(2008) Eric Irissou et al.   JOURNAL OF THERMAL SPRAY TECHNOLOGY

On the Evolution of Friction-Induced Microstructures in Single Crystal Nickel

(2008) SV Prasad et al.   MICROSCOPY AND MICROANALYSIS

Influence of processing temperature and die angle on the grain microstructure produced by severe deformation of an Al–7% Si alloy

(2007) I. Gutierrez-Urrutia et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Quantitative in situ measurement of transfer film thickness by a Newton's rings method

(2007) Kathryn J. Wahl et al.   WEAR