Journal
SENSORS AND ACTUATORS B-CHEMICAL
Volume 161, Issue 1, Pages 1067-1073Publisher
ELSEVIER SCIENCE SA
DOI: 10.1016/j.snb.2011.12.011
Keywords
Polymer microfluidic device; COC; Thermal bonding; Diffusion; Molecular weight
Funding
- Singapore-MIT Alliance
Ask authors/readers for more resources
Thermal bonding of the same polymer is an important method for obtaining good thermal sealing between two polymeric substrates in microfluidic devices. It is worthwhile to use different grades of the same polymer which have different glass transition temperatures (T-g) because no change in microchannel profile and dimensions would occur in the higher T-g substrate during thermal bonding. However, apart from using different grades of a polymer with different T-g, there is no fundamental basis for the selection of suitable substrate pairs. Thus an in-depth study of the thermal bond strength of different grades of TOPAS cyclic olefin copolymer (COC) was conducted. The strength development and chain inter-diffusion across the bonded interface between different TOPAS grades was studied, and the influence of molecular weight (M-w) and bonding temperature was considered. Bonding in both symmetric (between two substrates of the same COC grade) and non-symmetric interfaces (between two substrates of different COC grades) was compared. Bonding was conducted at both below and above the T-g. The thermal bond strengths were assessed from lap shear specimens prepared using a range of bonding temperature, time and pressure. Thermal bonding between 5013 and 6015 polymer substrates at 125 degrees C for 6 min time under 2 MPa pressure was found to be the most favorable conditions at which no deformation in the geometry of the COC microchannel has been observed. The failure surfaces of the specimens were characterized by scanning electron microscopy (SEM). Through the above, a basis for selecting different grades of TOPAS to obtain thermally bonded COC microfluidic devices with high strength was developed. The principles established are believed to be applicable to other polymeric microfluidic chips. (C) 2011 Elsevier B.V. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available