Investigation of tool wear and surface roughness during machining of ZA43–SiCp composite using full factorial approach

High-cycle fatigue behavior of severe plastically deformed binary Zn–60Al alloy by equal-channel angular extrusion

(2012) Murat Aydın   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Effect of machining parameters on surface roughness and tool wear for 7075 Al alloy SiC composite

(2010) Rajesh Kumar Bhushan et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Investigations of flank wear, cutting force, and surface roughness in the machining of Al-6061–TiB2 in situ metal matrix composites produced by flux-assisted synthesis

(2010) V. Anandakrishnan et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Tool life modeling for evaluating the effects of cutting speed and reinforcements on the machining of particle reinforced metal matrix composites

(2010) Metin Kök   International Journal of Minerals Metallurgy and Materials

The effect of structure on tensile properties of directionally solidified Zn-based alloys

(2010) A.E. Ares et al.   JOURNAL OF CRYSTAL GROWTH

Effect of equal-channel angular extrusion on the mechanical and tribological properties of as-cast Zn–40Al–2Cu–2Si alloy

(2010) G. Purcek et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Study on tool wear and surface roughness in machining of particulate aluminum metal matrix composite-response surface methodology approach

(2009) M. Seeman et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Modeling of chip–tool interface friction to predict cutting forces in machining of Al/SiCp composites

(2009) Uday A. Dabade et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE