Reduction of void content of vacuum-assisted resin transfer molded composites by infusion pressure control
Published 2014 View Full Article
- Home
- Publications
- Publication Search
- Publication Details
Title
Reduction of void content of vacuum-assisted resin transfer molded composites by infusion pressure control
Authors
Keywords
-
Journal
POLYMER COMPOSITES
Volume 36, Issue 9, Pages 1629-1637
Publisher
Wiley
Online
2014-05-06
DOI
10.1002/pc.23071
References
Ask authors/readers for more resources
Related references
Note: Only part of the references are listed.- Simulation of void formation in liquid composite molding processes
- (2013) C. DeValve et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Effects of defects on interlaminar tensile fatigue behavior of carbon/epoxy composites
- (2013) Guillaume Seon et al. COMPOSITES SCIENCE AND TECHNOLOGY
- Optimization of curing cycle in carbon fiber-reinforced laminates: Void distribution and mechanical properties
- (2013) S. Hernández et al. COMPOSITES SCIENCE AND TECHNOLOGY
- Influence of voids on damage mechanisms in carbon/epoxy composites determined via high resolution computed tomography
- (2013) A.E. Scott et al. COMPOSITES SCIENCE AND TECHNOLOGY
- Experimental investigation into the post-filling stage of the resin infusion process
- (2012) Q Govignon et al. JOURNAL OF COMPOSITE MATERIALS
- Bubble development in a polymeric resin under vacuum
- (2012) In Hwan Sul et al. POLYMER ENGINEERING AND SCIENCE
- Full-field monitoring of resin flow using an area-sensor array in a VaRTM process
- (2011) Ryosuke Matsuzaki et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Modeling and simulation of voids and saturation in liquid composite molding processes
- (2011) Chung Hae Park et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Experimental validation of post-filling flow in vacuum assisted resin transfer molding processes
- (2011) Pavel Simacek et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Effects of vacuum pressure, inlet pressure, and mold temperature on the void content, volume fraction of polyester/e-glass fiber composites manufactured with VARTM process
- (2011) Vishwanath R. Kedari et al. JOURNAL OF COMPOSITE MATERIALS
- Influence of Voids on the Tensile Performance of Carbon/epoxy Fabric Laminates
- (2011) Hongyan Zhu et al. JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY
- Mechanical properties of composite structures fabricated with the vacuum induced preform relaxation process
- (2010) Justin B. Alms et al. COMPOSITE STRUCTURES
- Simulation of the reinforcement compaction and resin flow during the complete resin infusion process
- (2009) Q. Govignon et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Full field monitoring of the resin flow and laminate properties during the resin infusion process
- (2008) Q. Govignon et al. COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING
- Bubble growth with chemical reactions in microchannels
- (2008) B.R. Fu et al. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
- Measurement of Void Content and Distribution in Composite Materials through Digital Microscopy
- (2008) S. Paciornik et al. JOURNAL OF COMPOSITE MATERIALS
- Modeling of resin infusion in vacuum assisted resin transfer molding
- (2008) Young Seok Song et al. POLYMER COMPOSITES
Find Funding. Review Successful Grants.
Explore over 25,000 new funding opportunities and over 6,000,000 successful grants.
ExploreAsk a Question. Answer a Question.
Quickly pose questions to the entire community. Debate answers and get clarity on the most important issues facing researchers.
Get Started