Effect of oxygen concentration on highly diluted charge compression ignition combustion in an optical engine

To implement low temperature diesel combustion, the charge dilution with nitrogen was used in an optical engine to simulate exhaust gas recirculation of a metal engine. In-cylinder visualization is focused on a regime of the simultaneous reduction in soot and nitrogen oxides (NOx) emissions, which is demonstrated by the metal engine experiment. Injection timing was varied from 30 to 20 crank angle (CA) before top dead center (BTDC) by 5 degrees increment, and the oxygen concentration was between approximately 8 and 11%. For an injection timing of a 20 degrees CA BTDC, approximately 10% oxygen concentration showed two peaks of natural luminosity: one corresponds to the OH chemiluminescence from high temperature heat release and the other coincides with soot luminescence in a diffusive flame. Both peaks are reduced as the oxygen concentration at the intake stream decrease; in addition, the luminosity corresponding to the diffusive flame is not apparent below oxygen concentration of approximately 9% in this experiment. For an injection timing of 30 degrees CA BTDC with the oxygen concentration being similar to that of 20 degrees CA BTDC, the luminosity is weak for chemiluminescence and not apparent for soot luminescence. The earlier injection timing allows a prolonged mixing period; thus, a relatively well-premixed charge resulted in reduction of soot particles emitting soot incandescence. This result is also supported by the longer ignition delay calculated from the metal engine test. (C) 2015 Elsevier Ltd. All rights reserved.