Investigation on mechanical properties of laser welded joints for Ti–6Al–4V titanium alloy

Local Creep Evaluation of P92 Steel Weldment by Small Punch Creep Test

(2013) Bumjoon Kim et al.   ACTA MECHANICA SOLIDA SINICA

Laser welding of copper with stellite 6 powder and investigation using LIBS technique

(2012) B. Genc Oztoprak et al.   OPTICS AND LASER TECHNOLOGY

An investigation into the mechanical behavior and microstructural evolution of the accumulative roll bonded AZ31 Mg alloy upon annealing

(2011) Ali A. Roostaei et al.   MATERIALS & DESIGN

Microstructural stability and high-temperature mechanical properties of AZ91 and AZ91+2RE magnesium alloys

(2011) R. Mahmudi et al.   MATERIALS & DESIGN

Microstructural evolution of fusion zone in laser beam welds of pure titanium

(2011) H. Liu et al.   MATERIALS CHARACTERIZATION

Pulsed Nd:YAG laser seam welding of AISI 316L stainless steel thin foils

(2010) Vicente Afonso Ventrella et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

A simple dislocation model of deformation resistance of ultrafine-grained materials explaining Hall–Petch strengthening and enhanced strain rate sensitivity

(2009) W. Blum et al.   ACTA MATERIALIA

Effect of hydrogen on fracture behavior of Ti–6Al–4V alloy by in-situ tensile test

(2009) B.G. Yuan et al.   INTERNATIONAL JOURNAL OF HYDROGEN ENERGY

Optimisation of energy absorbing liner for equestrian helmets. Part II: Functionally graded foam liner

(2009) L. Cui et al.   MATERIALS & DESIGN

Finite element analysis of shear punch testing and experimental validation

(2009) Sunil Goyal et al.   MATERIALS & DESIGN

On the use of a sub-scale thermomechanical simulator to obtain accurate tensile properties of (α+β)- and β-processed Ti–6Al–4V

(2009) B. Peterson et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of welding speed on butt joint quality of Ti–6Al–4V alloy welded using a high-power Nd:YAG laser

(2009) X. Cao et al.   OPTICS AND LASERS IN ENGINEERING

Laser welding of Ti6Al4V titanium alloys

(2008) E. Akman et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Application of the CEN (European Committee for Standardization) small punch creep testing code of practice to a representative repair welded P91 pipe

(2008) D.T. Blagoeva et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Effect of microstructure on impact toughness of pulsed current GTA welded α–β titanium alloy

(2007) M. Balasubramanian et al.   MATERIALS LETTERS

Microstructural characteristics and mechanical properties of Ti–6Al–4V friction stir welds

(2007) Yu Zhang et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING