4.4 Article

Edge-released, piezoelectric MEMS acoustic transducers in array configuration

Journal

Publisher

IOP PUBLISHING LTD
DOI: 10.1088/0960-1317/22/2/025005

Keywords

-

Funding

  1. Defense Advanced Research Projects Agency (DARPA) [W31P4Q-08-1-0010]

Ask authors/readers for more resources

A sensitive, broad-bandwidth piezoelectric microelectromechanical systems (MEMS) transducer based on frequency interleaving of resonant transducers was designed and fabricated. A sputter-deposited piezoelectric zinc oxide (ZnO) thin film on the diaphragm is used to sense and generate acoustic pressure. A high compliance cantilever and spiral-beam-supported diaphragms are designed and built on the edge-released MEMS structure to release initial residual stress and to avoid in-plane tension when bent. Stress compensation has been achieved by adjusting the thickness of each layer of the cantilever and by compensating for the ZnO film's compressive stress with the bimorph structure of the spiral-beam. For a given pressure level and diaphragm size, the maximum strain on the spiral-beam-supported diaphragm is about an order of magnitude larger than that of a rectangular cantilever diaphragm. Also, the acoustic transducer built on the spiral-beam-supported diaphragm has a much higher sensitivity (but with less tolerance on the fabrication process variation and at the cost of lower usable bandwidth) than the one built on a rectangular cantilever diaphragm. By connecting many transducers in parallel, both the sensitivity and acoustic output were improved about 30 times. The interleaving of the transducers increased not only the sensitivity, but also broadened the useable bandwidth.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.4
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available