Optimisation of dead-end filtration conditions for an immersed anoxic membrane bioreactor

The optimisation of the energy demand in the application of dead-end filtration in an immersed membrane bioreactor applied to groundwater denitrification has been studied. Filtration cycle length was varied at a set flux to control the amount of foulant deposited at the membrane surface. Physical cleans comprising a simultaneous backflush and gas injection were subsequently instigated and the reversibility of the deposit determined by the residual resistance, R-res. Examination of R-res versus flux and cycle length variation indicated an operational envelope where limited fouling occurred. The transition from limited fouling to extensive fouling was indicated by a parameter based on the critical accumulated mass, indicating incipient deposit consolidation. The transition between regions became less severe when the solids retention time was increased from 10 to 25 and 40 days. This was apparently related to a shift in bulk physical characteristics. Nevertheless, low residual fouling was observed during long-term filtration when operating below the critical mass, resulting in a 20x reduction in energy demand over that of constant gas injection. Crown Copyright (C) 2008 Published by Elsevier B.V. All rights reserved