Prediction of cutting force, tool wear and surface roughness of Al6061/SiC composite for end milling operations using RSM

Effect of turning parameters on surface roughness of A356/5% SiC composite produced by electromagnetic stir casting

(2013) S. P. Dwivedi et al.   Journal of Mechanical Science and Technology

Analysis and prediction of tool wear, surface roughness and cutting forces in hard turning with CBN tool

(2012) Samir Khamel et al.   Journal of Mechanical Science and Technology

Modeling and optimization of hard turning of X38CrMoV5-1 steel with CBN tool: Machining parameters effects on flank wear and surface roughness

(2011) Hamdi Aouici et al.   Journal of Mechanical Science and Technology

Indirect cutting force measurement in the micro end-milling process based on frequency analysis of sensor signals

(2010) Bong-Cheol Shin et al.   Journal of Mechanical Science and Technology

Analysis of directional factors in milling: importance of multi-frequency calculation and of the inclusion of the effect of the helix angle

(2009) Mikel Zatarain et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Optimization of machining parameters of Al/SiC-MMC with ANOVA and ANN analysis

(2008) N. Muthukrishnan et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Experimental study of surface integrity during end milling of Al/SiC particulate metal–matrix composites

(2007) N. Suresh Kumar Reddy et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Investigation of mechanical and machinability properties of SiC particle reinforced Al-MMC

(2007) Tamer Ozben et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY