Effect of SiC content on the processing, compaction behavior, and properties of Al6061/SiC/Gr hybrid composites

Analysis of the compaction behavior of Al–SiC nanocomposites using linear and non-linear compaction equations

(2011) H.R. Hafizpour et al.   ADVANCED POWDER TECHNOLOGY

Effect of silicon carbide particulates on wear resistance of graphitic aluminium matrix composites

(2010) S. Suresha et al.   MATERIALS & DESIGN

Effect of temperature on the frictional behaviour of an aluminium alloy sliding against steel during ball-on-disc tests

(2009) L. Wang et al.   TRIBOLOGY INTERNATIONAL

Effect of reinforcement coatings on the dry sliding wear behaviour of aluminium/SiC particles/carbon fibres hybrid composites

(2009) A. Ureña et al.   WEAR

The effect of lubrication in reducing net friction in warm powder compaction process

(2008) S.S.M. Nor et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Study of machinable SiC/Gr/Al composites

(2008) Jinfeng Leng et al.   JOURNAL OF MATERIALS SCIENCE

Investigation of tribological and mechanical properties Al2O3–SiC reinforced Al composites manufactured by casting or P/M method

(2008) Bekir Sadık Ünlü   MATERIALS & DESIGN

Analysis of the effect of reinforcement particles on the compressibility of Al–SiC composite powders using a neural network model

(2008) H.R. Hafizpour et al.   MATERIALS & DESIGN

Development and performance analysis of novel cast copper–SiC–Gr hybrid composites

(2008) C.S. Ramesh et al.   MATERIALS & DESIGN

Preparation and mechanical properties of SiC-reinforced Al6061 composite by mechanical alloying

(2008) N. Parvin et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Mechanical properties of SiC/Gr/Al composites fabricated by squeeze casting technology

(2008) J LENG et al.   SCRIPTA MATERIALIA

Influence of graphite content on the dry sliding and oil impregnated sliding wear behavior of Al 2024–graphite composites produced by in situ powder metallurgy method

(2008) F. Akhlaghi et al.   WEAR

Analyses of the fundamental parameters of cold die compaction of powder metallurgy

(2007) H.A. Al-Qureshi et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Compaction, sintering and mechanical properties of elemental 6061 Al powder with and without sintering aids

(2007) N. Showaiter et al.   MATERIALS & DESIGN