An Investigation of Process Parameter Modifications on Additively Manufactured Inconel 718 Parts

Correlation of mechanical properties to microstructure in Inconel 718 fabricated by Direct Metal Laser Sintering

(2018) Bryton Farber et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Synchrotron-Based X-ray Microtomography Characterization of the Effect of Processing Variables on Porosity Formation in Laser Power-Bed Additive Manufacturing of Ti-6Al-4V

(2017) Ross Cunningham et al.   JOM

Formation of the Ni3Nb δ-Phase in Stress-Relieved Inconel 625 Produced via Laser Powder-Bed Fusion Additive Manufacturing

(2017) Eric A. Lass et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Evaluating the Effect of Processing Parameters on Porosity in Electron Beam Melted Ti-6Al-4V via Synchrotron X-ray Microtomography

(2016) Ross Cunningham et al.   JOM

Multiscale modeling of the mechanical behavior of IN718 superalloy based on micropillar compression and computational homogenization

(2015) A. Cruzado et al.   ACTA MATERIALIA

Enhancement of Low-Cycle Fatigue Performance From Tailored Microstructures Enabled by Electron Beam Melting Additive Manufacturing Technology

(2015) Philip A. Morton et al.   JOURNAL OF MECHANICAL DESIGN

Rationalization of Microstructure Heterogeneity in INCONEL 718 Builds Made by the Direct Laser Additive Manufacturing Process

(2014) Yuan Tian et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Study on microstructure and mechanical properties of laser rapid forming Inconel 718

(2007) Xiaoming Zhao et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING