Low-Temperature Nitriding of Nanocrystalline Stainless Steel and Its Effect on Improving Wear and Corrosion Resistance

In this study, an ultrafine-grained surface layer with the average grain size of about 10 nm was fabricated on a stainless steel plate by surface mechanical attrition treatment (SMAT). Plasma nitriding of the samples was carried out by a low-frequency pulse-excited plasma unit. Optical microscopy, x-ray diffraction, scanning electron microscopy, transmission electron microscopy, micro-indentation, and pin-on-disk wear and corrosion experiments were performed for characterization before and after plasma nitriding. It is found that the pre-SMATed sample developed a nitrided layer twice as thick as that on the as-received sample under the same nitriding conditions (300 A degrees C for 4 h), which can be mainly attributed to the fast diffusion of nitrogen along grain boundaries in the nanostructured layer induced by means of SMAT. Results showed that nitriding layers of the as-received and pre-SMATed samples up to 300 A degrees C are dominated by S-phase (gamma(N)), but its peak intensity for the pre-SMATed sample is sharper than that of the as-received one. During 500 A degrees C nitriding treatment, the nitrogen would react with Cr in the steel to form CrN precipitates, which would lead to the depletion of chromium in the solid solution phase of the nitrided layer. Furthermore, the nitrided layer of the pre-SMATed sample exhibited a high hardness, and an excellent wear and corrosion resistance.