Compaction influence on spring-in of thin composite parts: Experimental and numerical results

To design the cure process of thick composite parts: experimental and numerical results

(2013) L. Sorrentino et al.   ADVANCED COMPOSITE MATERIALS

Process distortions in prepreg manufacturing – An experimental study on CFRP L-profiles

(2013) E. Kappel et al.   COMPOSITE STRUCTURES

Spring-in and Warpage — Progress in Simulating Manufacturing Aspects

(2013) K. Rohwer et al.   MECHANICS OF COMPOSITE MATERIALS

Generation of heat and stress during the cure of polymers used in fiber composites

(2012) Christian Heinrich et al.   INTERNATIONAL JOURNAL OF ENGINEERING SCIENCE

Microlevel manufacturing process simulation of carbon fiber/epoxy composites to analyze the effect of chemical and thermal induced residual stresses

(2012) Christian Brauner et al.   JOURNAL OF COMPOSITE MATERIALS

Estimation of kinetic parameters of composite materials during the cure process by using wavelet transform and mollification method

(2011) S.D. Farahani et al.   INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER

Effect of thermal residual stresses on matrix failure under transverse tension at micromechanical level: A numerical and experimental analysis

(2010) E. Correa et al.   COMPOSITES SCIENCE AND TECHNOLOGY

Process-induced deformation of composite T-stiffener structures

(2009) Chensong Dong   COMPOSITE STRUCTURES

Modelling of the spring-in phenomenon in curved parts made of a thermosetting composite

(2009) Nuri Ersoy et al.   COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING