Effects of the erosion zone of magnetron sputtering targets on the spatial distribution of structural and electrical properties of transparent conductive Al-doped ZnO polycrystalline films

We investigated the effects of the erosion zone of magnetron sputtering (MS) targets on the deposition rates of magnetron-sputtered Al-doped ZnO (AZO) polycrystalline films and on the structural and electrical properties of the resulting AZO films. We deposited AZO films on glass substrates at a substrate temperature of 200 degrees C, which were placed parallel to the target surface, by radio frequency (RF), direct current (DC) or RF-superimposed DC (RF/DC) MS. Sintered AZO targets with an Al2O3 content of 2.0 wt. % were used. The structural and electrical properties were investigated by X-ray diffraction and Hall-effect measurements, respectively. For RF-magnetron-sputtered AZO films, the results of the electron probe microanalyzer and photo luminescence measurements show that the effects of the erosion zone of the targets on the properties were very small at any given substrate position, resulting in small differences in the structural and electrical properties among the AZO films grown at different substrate positions. In the case of DC-magnetron-sputtered AZO films, residual damage owing to recoiling Ar atoms was found, particularly for the films grown at substrate positions in the area opposite to the erosion zone of the targets. This gives rise to the formation of nonradiative recombination centers, low carrier concentration, and high contribution of grain boundary scattering to carrier transport owing to poor alignments between columnar grains, resulting in low Hall mobility. In this study, we prove that the use of the RF/DC MS technique is effective in reducing the amount of residual damage. Published by AIP Publishing.