Quantitative and kinetic TG-FTIR study of biomass residue pyrolysis: Dry distiller's grains with solubles (DDGS) and chicken manure

New energy policies all over the world are trying to tackle high oil prices and climate change by promoting the use of biomass to produce heat, electricity and liquid transportation fuels. In this paper we studied two different secondary fuels: dry distiller's grains with solubles (DDGS) and chicken manure. These materials have high content of nitrogen and ashes which limit their usage in thermal applications due to potential excessive NOx emissions and problems of slagging, fouling, corrosion and loss of fluidization. The fuels tested here were received from industrial partners. In order to reduce the ash content the fuels were pre-treated using water leaching pre-treatment. Pyrolysis of these fuels has been monitored through a TG-FTIR set-up. Quantification of the following volatile species was possible: CO, CO2, CH4, HCN, NH3, HNCO, H2O. The water leaching appeared to decrease the amount of ashes in both samples and remove some of the troublesome compounds like Cl, S and K. The DDGS thermogravimetric curve showed three main peaks at 280 degrees C, 330 degrees C and 402 degrees C with a total weight loss of around 79%wt(a.r.) (on an as received basis). NH3 is the main N-compound released at low temperatures with a peak at 319 degrees C. HNCO and HCN were detected at higher temperatures of around 400 degrees C. Chicken manure reacted in four stages with peaks at 280 degrees C, 324 degrees C, 430 degrees C and 472 degrees C with a total average weight loss of 66%wt(a.r.) The main N-compound was HNCO, released at 430 degrees C. Ammonia was detected during the whole measurement, while HCN presented peaks of reactivity at 430 degrees C and 472 degrees C. Kinetic analysis was applied using a distributed activation energy method (DAEM) using discrete and Gaussian distributions and data for further modeling purposes were retrieved and presented. (C) 2009 Elsevier B.V. All rights reserved.