Investigation of electrochemical hydride generation coupled to microwave plasma torch optical emission spectrometry for the determination of arsenic: analytical figures of merit, interference studies and applications to environmentally relevant samples

A continuous flow thin layer electrolysis cell with a Pt cathode in combination with a microwave plasma torch operated with Ar as working gas was used for the optical emission spectrometric determination of As with the hydride technique. Under the optimised conditions the limit of detection (3 sigma) in the case of the As(I) 228.81 nm emission line was 81 ng mL(-1). Especially the influence of the transition metals Cu(II), Fe(III) and Ni(II), of the hydride forming elements Sb(III), Se(IV) and Sn(II) and of Na on the determination of As was studied. Cu(II) was found to be the strongest interferent, as in the presence of 100 mu g mL(-1) of Cu(II) the signal for 3 mu g mL(-1) of As was reduced to 4% of the signal without interferent. Sn(II) and Sb(III) were found to yield an increase of the signal for As. L-cysteine and KI/ascorbic acid (1 : 1) at a concentration of 2% were found effective to reduce the interferences of Cu(II), Fe(III) and Ni(II). For a solution containing 3 mu g mL(-1) of As and 100 mu g mL(-1) of Ni(II) it was shown that in the presence of L-cysteine or KI/ascorbic acid the signal for As was 99% and 94% of the one without interferent, whereas it was only 43% without masking reagents. The procedure could be used for the determination of As in a digested coal fly ash standard reference material (NIST SRM 1633a (R)) with a certified value of 145 +/- 15 mu g g(-1) for As. A concentration of 131 +/- 15 mu g g(-1) was found. Additionally, As could be determined in two process water samples from a copper refinery. It was found that the amount of As determined with ECHG-MPT-OES agrees well with the values determined by FAAS and ICP-OES at the 0.02 and 1.6 g L(-1) level, respectively.