Impact of intermetallic precipitates on the tribological and/or corrosion performance of cast aluminium alloys: a short review

Effects of solute content on grain refinement in an isothermal melt

(2011) H. Men et al.   ACTA MATERIALIA

Effect of Al2Cu precipitates size and mass transport on the polarisation behaviour of age-hardened Al–Si–Cu–Mg alloys in 0.05M NaCl

(2011) A.C. Vieira et al.   ELECTROCHIMICA ACTA

Isothermal Modeling of Meniscus Oscillation in the Continuous Strip Casting Process

(2011) Kevin W. Wilcox et al.   JOURNAL OF FLUIDS ENGINEERING-TRANSACTIONS OF THE ASME

The effect of Al8Mn5 intermetallic particles on grain size of as-cast Mg–Al–Zn AZ91D alloy

(2010) Y. Wang et al.   INTERMETALLICS

Effect of Fe-rich intermetallics on the wear behavior of eutectic Al–Si piston alloy (LM13)

(2010) V. Abouei et al.   MATERIALS & DESIGN

Enhanced heterogeneous nucleation in AZ91D alloy by intensive melt shearing

(2009) Z. Fan et al.   ACTA MATERIALIA

Investigation of mechanical properties of intermetallic phases in multi-component Al–Si alloys using hot-stage nanoindentation

(2009) C.-L. Chen et al.   INTERMETALLICS

Influence of additives on the microstructure and tensile properties of near-eutectic Al–10.8%Si cast alloy

(2009) A.M.A. Mohamed et al.   MATERIALS & DESIGN

Effect of Sr and solidification conditions on characteristics of intermetallic in Al–Si 319 industrial alloys

(2009) J. Espinoza-Cuadra et al.   MATERIALS & DESIGN

Role of silicon in resisting subsurface plastic deformation in tribology of aluminium–silicon alloys

(2009) Anirban Mahato et al.   TRIBOLOGY INTERNATIONAL

Effect of high rates of mass transport on oxygen reduction at copper electrodes: Implications for aluminium corrosion

(2008) Anna L. Colley et al.   ELECTROCHEMISTRY COMMUNICATIONS

The influence of MgSi particle reactivity and dissolution processes on corrosion in Al–Mg–Si alloys

(2008) Fabian Eckermann et al.   ELECTROCHIMICA ACTA

Correlation of microstructure with mechanical properties and fracture toughness of A356 aluminum alloys fabricated by low-pressure-casting, rheo-casting, and casting–forging processes

(2008) Kyuhong Lee et al.   ENGINEERING FRACTURE MECHANICS

Effect of grain refinement and modification on the dry sliding wear behaviour of eutectic Al–Si alloys

(2008) T.M. Chandrashekharaiah et al.   TRIBOLOGY INTERNATIONAL

Cross-section corrosion-potential profiles of aluminum-alloy brazing sheets observed by the flowing electrolyte scanning-droplet-cell technique

(2007) Koji Fushimi et al.   ELECTROCHIMICA ACTA

Solution strengthening and age hardening capability of Al–Mg–Mn alloys with small additions of Cu

(2007) Z. Zhu et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING