Analyzing dissimilar friction stir welding of AA5754/AA7075

AA5754/AA7075 was butt-welded by friction stir welding, and the joint of each weld case was identified by ultimate tensile strength, percentage of elongation, and hardness. Moreover, the significance of each parameter was investigated, and a mathematical relation was constructed by regression analysis. A defect-free joint was achieved in the case of a weld produced with 1000 rpm of tool rotational speed, 80 mm/min of welding speed, and an 22-mm tool shoulder diameter. Most of the failures are located at the bottom of the pin and side of AA7075. The ultimate tensile strength (UTS) decreases with increasing welding speed (WS) or increasing tool rotational speed (TRS). Hardness distribution in the weld zones varied dependent on the nugget zone formation affected by TRS and WS. The present study also investigated the significance and contribution of each parameter on the UTS by analysis of variance (ANOVA). From the results of ANOVA, the conclusion reached is that the all the parameters have a great influence on UTS. The contributions are 41.41 % for WS, 17.58 % for diameter, and 13.28 % for TRS. Moreover, a full quadratic model was constructed between the parameters and the UTS value. The results show that the variation from the predicted values was between 0.41 % and 10.36 %. The strength of the model was analyzed by R-Sq. The achieved R-Sq is 0.892, which means that there is a strong relation between predicted and actual values.