Manufacturing variation models in multi-station machining systems

Tolerance analysis in machining using the model of manufactured part (MMP) – comparison and evaluation of three different approaches

(2011) Mojtaba Kamali Nejad et al.   INTERNATIONAL JOURNAL OF COMPUTER INTEGRATED MANUFACTURING

Design of multi-station manufacturing processes by integrating the stream-of-variation model and shop-floor data

(2011) Jose V. Abellan-Nebot et al.   JOURNAL OF MANUFACTURING SYSTEMS

Quality prediction and compensation in multi-station machining processes using sensor-based fixtures

(2011) José V. Abellan-Nebot et al.   ROBOTICS AND COMPUTER-INTEGRATED MANUFACTURING

Joint allocation of measurement points and controllable tooling machines in multistage manufacturing processes

(2010) Yibo Jiao et al.   IIE TRANSACTIONS

3D Simulation of Manufacturing Defects for Tolerance Analysis

(2010) M. Kamali Nejad et al.   JOURNAL OF COMPUTING AND INFORMATION SCIENCE IN ENGINEERING

Quality-assured setup planning based on the stream-of-variation model for multi-stage machining processes

(2009) Jian Liu et al.   IIE TRANSACTIONS

Simulation of the geometrical defects of manufacturing

(2009) M. Kamali Nejad et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

Integrating GD&T into dimensional variation models for multistage machining processes

(2009) Jean-Philippe Loose et al.   INTERNATIONAL JOURNAL OF PRODUCTION RESEARCH

Variation Propagation Analysis for Multistation Assembly Process With Consideration of GD&T Factors

(2009) Zhenyu Kong et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME

Engineering-Driven Factor Analysis for Variation Source Identification in Multistage Manufacturing Processes

(2008) Jian Liu et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME