Influence of High-Pressure Coolant Assistance on the Machinability of the Titanium AlloyTi555–3

Interrupted machining analysis for Ti6Al4V and Ti5553 titanium alloys using physical vapor deposition (PVD)–coated carbide inserts

(2013) Navneet Khanna et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Degradation modes and tool wear mechanisms in finish and rough machining of Ti17 Titanium alloy under high-pressure water jet assistance

(2013) Y. Ayed et al.   WEAR

An experimental study of the effect of high-pressure water jet assisted turning (HPWJAT) on the surface integrity

(2011) Malek Habak et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

A comparison of cryogenic and high pressure emulsion cooling technologies on tool life and chip morphology in Ti–6Al–4V cutting

(2011) M.J. Bermingham et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

Cryogenic turning of the Ti–6Al–4V alloy with modified cutting tool inserts

(2010) M. Dhananchezian et al.   CRYOGENICS

Effects of coolant pressure on chip formation while turning Ti6Al4V alloy

(2009) Suresh Palanisamy et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Investigation of machining performance in high-pressure jet assisted turning of Inconel 718: An experimental study

(2009) C. Courbon et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Characteristics of cutting forces and chip formation in machining of titanium alloys

(2009) S. Sun et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Some studies on high-pressure cooling in turning of Ti–6Al–4V

(2008) A.K. Nandy et al.   INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE

Machinability of titanium alloys (Ti6Al4V and Ti555.3)

(2008) P.-J. Arrazola et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

EFFECT OF COOLANT PRESSURE, NOZZLE DIAMETER, IMPINGEMENT ANGLE AND SPOT DISTANCE IN HIGH PRESSURE COOLING WITH NEAT OIL IN TURNING Ti-6AL-4V

(2008) A. K. Nandy et al.   MACHINING SCIENCE AND TECHNOLOGY

Influence of thermal conductivity on wear when machining titanium alloys

(2008) H.A. Abdel-Aal et al.   TRIBOLOGY INTERNATIONAL