Reduction of water droplets effects in steam turbine blade using Multi-objective optimization of hot steam injection

Thermo-hydraulic analysis of EuroTrough-150 solar receiver with porous foam by using CFD and MCRT techniques

(2022) Arash Rezaei Gorjaei et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

Wet steam flow and condensation loss in turbine blade cascades

(2021) Chuang Wen et al.   APPLIED THERMAL ENGINEERING

A blackbox optimization of volumetric heating rate for reducing the wetness of the steam flow through turbine blades

(2021) Davood Hoseinzade et al.   ENERGY

Numerical Simulation of Nanofluid Flow in a Channel Using Eulerian–Eulerian Two-Phase Model

(2021) Arash Rezaei Gorjaei et al.   INTERNATIONAL JOURNAL OF THERMOPHYSICS

A Novel Dehumidification Strategy to Reduce Liquid Fraction and Condensation Loss in Steam Turbines

(2021) Yan Yang et al.   Entropy

A modified model of the suction technique of wetness reducing in wet steam flow considering power-saving

(2021) Amir Momeni Dolatabadi et al.   ENERGY

Optimization variables of the injection of hot-steam into the non-equilibrium condensing flow using TOPSIS method

(2021) Amir Momeni Dolatabadi et al.   INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER

Reduction entropy generation and condensation by NaCl particle injection in wet steam supersonic nozzle

(2021) Guojie Zhang et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

The best angle of hot steam injection holes in the 3D steam turbine blade cascade

(2021) Amir Kafaei et al.   INTERNATIONAL JOURNAL OF THERMAL SCIENCES

Polydispersed droplet spectrum and exergy analysis in wet steam flows using method of moments

(2020) Hongbing Ding et al.   APPLIED THERMAL ENGINEERING

Experimental and numerical research on the effect of the inlet steam superheat degree on the spontaneous condensation in the IWSEP nozzle

(2020) Guojie Zhang et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Effect of the nonaxisymmetric endwall on wet steam condensation flow in a stator cascade

(2019) Xu Han et al.   Energy Science & Engineering

Investigation of the comprehensive performance of turbine stator cascades with heating endwall fences

(2019) Xu Han et al.   ENERGY

The relationship between the nucleation process and boundary conditions on non-equilibrium condensing flow based on the modified model

(2019) Guojie Zhang et al.   INTERNATIONAL JOURNAL OF MULTIPHASE FLOW

Heat transfer and entropy generation of water–Fe3O4 nanofluid under magnetic field by Euler–Lagrange method

(2019) Arash Rezaei Gorjaei et al.   JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY

Entropy generation and exergy destruction in condensing steam flow through turbine blade with surface roughness

(2019) Hongbing Ding et al.   ENERGY CONVERSION AND MANAGEMENT

Investigating Heat Transfer and Skin Friction Using Water–CuO Nanofluid between Eccentric Channels

(2019) Arash Rezaei Gorjaei et al.   HEAT TRANSFER ENGINEERING

Design and optimization of novel dehumidification strategies based on modified nucleation model in three-dimensional cascade

(2019) Guojie Zhang et al.   ENERGY

Numerical investigation of novel dehumidification strategies in nuclear plant steam turbine based on the modified nucleation model

(2019) Guojie Zhang et al.   INTERNATIONAL JOURNAL OF MULTIPHASE FLOW

A comprehensive investigation of finding the best location for hot steam injection into the wet steam turbine blade cascade

(2019) Mohammad Ali Faghih Aliabadi et al.   ENERGY

The heat and mass transfer characteristics of superheated steam coupled with non-condensing gases in horizontal wells with multi-point injection technique

(2018) Fengrui Sun et al.   ENERGY

Investigating the entropy generation in condensing steam flow in turbine blades with volumetric heating

(2018) Masoud Vatanmakan et al.   ENERGY

Effect evaluation of a novel dehumidification structure based on the modified model

(2018) Guojie Zhang et al.   ENERGY CONVERSION AND MANAGEMENT

Analytical investigation of simultaneous effects of convergent section heating of Laval nozzle, steam inlet condition, and nozzle geometry on condensation shock

(2018) Makan Talebi Somesaraee et al.   JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY

CFD simulation of nanofluid forced convection inside a three-dimensional annulus by two-phase mixture approach: Heat transfer and entropy generation analyses

(2018) Arash Rezaei Gorjaei et al.   INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES

Numerical study of the dehumidification structure optimization based on the modified model

(2018) Guojie Zhang et al.   ENERGY CONVERSION AND MANAGEMENT

Performance analysis of superheated steam injection for heavy oil recovery and modeling of wellbore heat efficiency

(2017) Fengrui Sun et al.   ENERGY

Multi-objective optimization of hot steam injection variables to control wetness parameters of steam flow within nozzles

(2017) Mohadeseh Sadat Mirhoseini et al.   ENERGY

A numerical approach for obtaining type curves of superheated multi-component thermal fluid flow in concentric dual-tubing wells

(2017) Fengrui Sun et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Type curve analysis of superheated steam flow in offshore horizontal wells

(2017) Fengrui Sun et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Control of wetness fraction and liquid droplet size in wet steam two phase flows with hot steam injection

(2017) Mohadeseh Sadat Mirhoseini et al.   MECCANICA

Particle swarm optimization algorithm: an overview

(2017) Dongshu Wang et al.   SOFT COMPUTING

Origin of droplet size underprediction in modeling of low pressure nucleating flows of steam

(2016) Ali Afzalifar et al.   INTERNATIONAL JOURNAL OF MULTIPHASE FLOW

Effects of surface roughness on deviation angle and performance losses in wet steam turbines

(2015) H. Bagheri Esfe et al.   APPLIED THERMAL ENGINEERING

Analytic equations for the Wilson point in high-pressure steam flow through a nozzle

(2015) Hongbing Ding et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Experimental study of condensing steam flow in nozzles and linear blade cascade

(2015) Sławomir Dykas et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

A 3D method to evaluate moisture losses in a low pressure steam turbine: Application to a last stage

(2015) Xinggang Yu et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

An analytical method for Wilson point in nozzle flow with homogeneous nucleating

(2014) Hongbing Ding et al.   INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Numerical investigation of condensing flow in the last stage of low-pressure nuclear steam turbine

(2014) Yu Xinggang et al.   NUCLEAR ENGINEERING AND DESIGN

Experimental studies of polydispersed wet steam flows in a turbine blade cascade

(2014) Gennadiy Filippov et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY

Wet steam energy loss and related Baumann rule in low pressure steam turbines

(2013) Vaclav Petr et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY

Theoretical investigation of effects of local cooling of a nozzle divergent section for controlling condensation shock in a supersonic two-phase flow of steam

(2012) M. R. Mahpeykar et al.   MECCANICA

Reducing entropy generation by volumetric heat transfer in a supersonic two-phase steam flow in a Laval nozzle

(2011) M.R. Mahpeykar et al.   International Journal of Exergy

Single- and two-fluid models for steam condensing flow modeling

(2011) Sławomir Dykas et al.   INTERNATIONAL JOURNAL OF MULTIPHASE FLOW

A numerical investigation of two-phase steam flow around a 2-D turbine's rotor tip

(2009) Behnam Nikkhahi et al.   INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER

Steam condensing flow modeling in turbine channels

(2009) Włodzimierz Wróblewski et al.   INTERNATIONAL JOURNAL OF MULTIPHASE FLOW