Achieving ultra-high yield strength in austenitic low-density steel via drastic VC precipitation
出版年份 2022 全文链接
标题
Achieving ultra-high yield strength in austenitic low-density steel via drastic VC precipitation
作者
关键词
-
出版物
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
Volume 861, Issue -, Pages 144306
出版商
Elsevier BV
发表日期
2022-11-09
DOI
10.1016/j.msea.2022.144306
参考文献
相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。- Role of vanadium additions on tensile and cryogenic-temperature Charpy impact properties in hot-rolled high-Mn austenitic steels
- (2021) Jia-kuan Ren et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Multiphase precipitation and its strengthening mechanism in a V-containing austenite-based low density steel
- (2021) Mingxiang Liu et al. INTERMETALLICS
- Revisiting the formation mechanism of intragranular κ-carbide in austenite of a Fe-Mn-Al-Cr-C low-density steel
- (2021) Jianlei Zhang et al. SCRIPTA MATERIALIA
- Improvement of strength – ductility balance of B2-strengthened lightweight steel
- (2020) J.H. Hwang et al. ACTA MATERIALIA
- Combined κ-carbide precipitation and recovery enables ultra-high strength and ductility in light-weight steels
- (2020) Frederike Brasche et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Application of advanced experimental techniques to elucidate the strengthening mechanisms operating in microalloyed ferritic steels with interphase precipitation
- (2020) Navjeet Singh et al. ACTA MATERIALIA
- The influence of austenitization temperature on microstructural developments, mechanical properties, fracture mode and wear mechanism of Hadfield high manganese steel
- (2020) H.R. Jafarian et al. Journal of Materials Research and Technology-JMR&T
- Hadfield manganese austenitic steel: a review of manufacturing processes and properties
- (2019) Masoud Sabzi et al. Materials Research Express
- Effect of vanadium on microstructure and mechanical properties of bainitic forging steel
- (2019) Zhanhua Wang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Microstructures, mechanical properties and deformation of near-rapidly solidified low-density Fe-20Mn-9Al-1.2C-xCr steels
- (2019) Jianlei Zhang et al. MATERIALS & DESIGN
- Deformation behaviors and cyclic strength assessment of AZ31B magnesium alloy based on steady ratcheting effect
- (2018) Zhifeng Yan et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Control of inter/intra-granular κ -carbides and its influence on overall mechanical properties of a Fe-11Mn-10Al-1.25C low density steel
- (2018) Degang Liu et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Improvement of tensile properties in (austenite+ferrite+κ-carbide) triplex hot-rolled lightweight steels
- (2018) Hyejin Song et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- The Effect of Heat Treatment Process Parameters on Mechanical Properties, Precipitation, Fatigue Life, and Fracture Mode of an Austenitic Mn Hadfield Steel
- (2018) S. H. Mousavi Anijdan et al. JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE
- The effect of vanadium micro-alloying on the microstructure and the tensile behavior of TWIP steel
- (2017) Hojun Gwon et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Current state of Fe-Mn-Al-C low density steels
- (2017) Shangping Chen et al. PROGRESS IN MATERIALS SCIENCE
- Tensile Deformation Behavior of Fe-Mn-Al-C Low Density Steels
- (2016) Xiao-feng ZHANG et al. JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL
- Novel ultra-high-strength (ferrite + austenite) duplex lightweight steels achieved by fine dislocation substructures (Taylor lattices), grain refinement, and partial recrystallization
- (2015) Seok Su Sohn et al. ACTA MATERIALIA
- Size and orientation effects in partial dislocation-mediated deformation of twinning-induced plasticity steel micro-pillars
- (2015) Won Seok Choi et al. ACTA MATERIALIA
- Development of thermodynamic database for high Mn–high Al steels: Phase equilibria in the Fe–Mn–Al–C system by experiment and thermodynamic modeling
- (2015) Min-Su Kim et al. CALPHAD-COMPUTER COUPLING OF PHASE DIAGRAMS AND THERMOCHEMISTRY
- κ-carbide hardening in a low-density high-Al high-Mn multiphase steel
- (2015) W.J. Lu et al. MATERIALS LETTERS
- Influence of Al content on the strain-hardening behavior of aged low density Fe–Mn–Al–C steels with high Al content
- (2015) Z.Q. Wu et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Work hardening behavior involving the substructural evolution of an austenite–ferrite Fe–Mn–Al–C steel
- (2015) Leifeng Zhang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Sensitivity of novel 460MPa proof strength titanium–vanadium microalloyed high strength low alloy steels to annealing linespeed and soak temperature
- (2015) T. Taylor et al. MATERIALS & DESIGN
- Effects of ferrite volume fraction on the tensile deformation characteristics of dual phase twinning induced plasticity steel
- (2013) A. Imandoust et al. MATERIALS & DESIGN
- Microstructural evolution and strain hardening behavior during plastic deformation of Fe–12Mn–8Al–0.8C steel
- (2013) Zhi Qiang Wu et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Tensile deformation of a low density Fe–27Mn–12Al–0.8C duplex steel in association with ordered phases at ambient temperature
- (2013) Min Chul Ha et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Investigation on grain refinement and precipitation strengthening applied in high speed wire rod containing vanadium
- (2013) Da-yong Wu et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Elastic properties of face-centred cubic Fe–Mn–C studied by nanoindentation and ab initio calculations
- (2012) S. Reeh et al. ACTA MATERIALIA
- Multistage strain hardening through dislocation substructure and twinning in a high strength and ductile weight-reduced Fe–Mn–Al–C steel
- (2012) I. Gutierrez-Urrutia et al. ACTA MATERIALIA
- Advanced high strength steels for automotive industry
- (2012) R. KUZIAK et al. Archives of Civil and Mechanical Engineering
- Design for sustainability in automotive industry: A comprehensive review
- (2012) Ahmad Mayyas et al. RENEWABLE & SUSTAINABLE ENERGY REVIEWS
- Interactions between deformation-induced defects and carbides in a vanadium-containing TWIP steel
- (2012) Hung-Wei Yen et al. SCRIPTA MATERIALIA
- Tensile deformation of low-density Fe–Mn–Al–C austenitic steels at ambient temperature
- (2012) Kyung-Tae Park SCRIPTA MATERIALIA
- Low-density low-carbon Fe–Al ferritic steels
- (2012) R. Rana et al. SCRIPTA MATERIALIA
- Low-density steels
- (2012) Dong-Woo Suh et al. SCRIPTA MATERIALIA
- Influence of Al content and precipitation state on the mechanical behavior of austenitic high-Mn low-density steels
- (2012) I. Gutierrez-Urrutia et al. SCRIPTA MATERIALIA
- Precipitation strengthening in high manganese austenitic TWIP steels
- (2011) Colin Scott et al. International Journal of Materials Research
- Vanadium Microalloyed Bainitic Hot Strip Steels
- (2010) Tadeusz Siwecki et al. ISIJ INTERNATIONAL
- High-strength Fe–20Mn–Al–C-based Alloys with Low Density
- (2010) Yuji Sutou et al. ISIJ INTERNATIONAL
- Stacking fault energy and plastic deformation of fully austenitic high manganese steels: Effect of Al addition
- (2010) Kyung-Tae Park et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Relationship between Microstructures and Tensile Properties of an Fe-30Mn-8.5Al-2.0C Alloy
- (2010) Chih Lung Lin et al. MATERIALS TRANSACTIONS
- Excellent combination of strength and ductility in an Fe–9Al–28Mn–1.8C alloy
- (2010) K.M. Chang et al. SCRIPTA MATERIALIA
- Effect of aging on the microstructure and deformation behavior of austenite base lightweight Fe–28Mn–9Al–0.8C steel
- (2010) Kayoung Choi et al. SCRIPTA MATERIALIA
- Microband-induced plasticity in a high Mn–Al–C light steel
- (2008) Je Doo Yoo et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
Find the ideal target journal for your manuscript
Explore over 38,000 international journals covering a vast array of academic fields.
SearchAsk a Question. Answer a Question.
Quickly pose questions to the entire community. Debate answers and get clarity on the most important issues facing researchers.
Get Started