标题
A Review on Superplastic Formation Behavior of Al Alloys
作者
关键词
-
出版物
Advances in Materials Science and Engineering
Volume 2018, Issue -, Pages 1-17
出版商
Hindawi Limited
发表日期
2018-09-28
DOI
10.1155/2018/7606140
参考文献
相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。- Comparison between superplastic deformation mechanisms at primary and steady stages of the fine grain AA7475 aluminium alloy
- (2018) A.V. Mikhaylovskaya et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Insight into the microstructural evolution during cryo-severe plastic deformation and post-deformation annealing of aluminum and its alloys
- (2017) A. Dhal et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Microstructural evolution of 2099 Al Li alloy during friction stir welding process
- (2017) Yi Lin et al. MATERIALS CHARACTERIZATION
- High strain rate superplasticity in an Al–Mg–Sc–Zr alloy processed via simple rolling
- (2017) Mengjia Li et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Grain size versus microstructural stability in the high strain rate superplastic response of a severely friction stir processed Al-Zn-Mg-Cu alloy
- (2017) Alberto Orozco-Caballero et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Superplastic behavior of carbon nanotube reinforced aluminum composites fabricated by flake powder metallurgy
- (2017) Haiyue Huang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Precipitation in an Al-Zn-Mg-Cu alloy during isothermal aging: Atomic-scale HAADF-STEM investigation
- (2017) Xuesong Xu et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- High-strain-rate superplasticity of fine-grained Mg–6Zn–0.5Zr alloy subjected to low-temperature indirect extrusion
- (2017) Beomcheol Kim et al. SCRIPTA MATERIALIA
- Coupling of dislocations and precipitates: Impact on the mechanical behavior of ultrafine grained Al–Zn–Mg alloys
- (2016) Kaka Ma et al. ACTA MATERIALIA
- Strategy for severe friction stir processing to obtain acute grain refinement of an Al–Zn–Mg–Cu alloy in three initial precipitation states
- (2016) A. Orozco-Caballero et al. MATERIALS CHARACTERIZATION
- Characterizing precipitate evolution of an Al–Zn–Mg–Cu-based commercial alloy during artificial aging and non-isothermal heat treatments by in situ electrical resistivity monitoring
- (2016) Fulin Jiang et al. MATERIALS CHARACTERIZATION
- Superplastic behavior and microstructure evolution of a new Al-Mg-Sc-Zr alloy subjected to a simple thermomechanical processing
- (2016) Y.L. Duan et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Experimental verification of grain boundary-sliding controlled steady state superplastic flow in both continually and statically recrystallizing Al alloys
- (2016) K. Arun Babu et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Superplasticity behaviors of Al-Zn-Mg-Zr cold-rolled alloy sheet with minor Sc addition
- (2016) H. Xiang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Superplastic behaviour of Al-Mg-Zn-Zr-Sc-based alloys at high strain rates
- (2016) A.V. Mikhaylovskaya et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Achieving high strain rate superplasticity of an Al-Mg-Sc-Zr alloy by a new asymmetrical rolling technology
- (2016) Guofu Xu et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Achieving high superplasticity of a traditional thermal–mechanical processed non-superplastic Al–Zn–Mg alloy sheet by low Sc additions
- (2015) Yulu Duan et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Microstructural, mechanical and electrochemical behaviour of a 7017 Al–Zn–Mg alloy of different tempers
- (2015) Prasanta Kumar Rout et al. MATERIALS CHARACTERIZATION
- Effect of Sc and Zr additions on grain stability and superplasticity of the simple thermal–mechanical processed Al–Zn–Mg alloy sheet
- (2015) Y.L. Duan et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Excellent superplasticity and deformation mechanism of Al–Mg–Sc–Zr alloy processed via simple free forging
- (2015) Y.L. Duan et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Achieving high superplasticity of a new Al–Mg–Sc–Zr alloy sheet prepared by a simple thermal–mechanical process
- (2015) Xiaowu Cao et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Superplastic deformation mechanisms in fine-grained Al–Mg based alloys
- (2015) A.V. Mikhaylovskaya et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Mechanical properties of ultra-fine grained AZ91 magnesium alloy processed by friction stir processing
- (2015) J.A. del Valle et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Grain refinement and high strain rate superplasticity in alumunium 2024 alloy processed by high-pressure torsion
- (2015) Ali Alhamidi et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Hot ductility behavior of an extruded 7075 aluminum alloy
- (2015) M. Taheri-Mandarjani et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- High strain-rate superplasticity of fine- and ultrafine-grained AA5083 aluminum alloy at intermediate temperatures
- (2015) N. Fakhar et al. MATERIALS & DESIGN
- Grain structure and microtexture evolution during superplastic deformation of 5A90 Al-Li alloy
- (2014) Pan ZHANG et al. TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA
- Microstructures and properties of 2099 Al-Li alloy
- (2013) Yi Lin et al. MATERIALS CHARACTERIZATION
- Lowering the temperature for high strain rate superplasticity in an Al–Mg–Zn–Cu alloy via cooled friction stir processing
- (2013) A. Orozco-Caballero et al. MATERIALS CHEMISTRY AND PHYSICS
- Processing maps and microstructural evolution of isothermal compressed Al–Cu–Li alloy
- (2013) Hao Yin et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Superplasticity of the rolled and friction stir processed Al–4.5 Mg–0.35Sc–0.15Zr alloy
- (2013) Anton Smolej et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Evaluating the Superplastic Flow of a Magnesium AZ31 Alloy Processed by Equal-Channel Angular Pressing
- (2013) Roberto B. Figueiredo et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- The Evolution of Al-Li Base Products for Aerospace and Space Applications
- (2012) Roberto J. Rioja et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Influence of Processing Severity During Equal-Channel Angular Pressing on the Microstructure of an Al-Zn-Mg-Cu Alloy
- (2012) Carmen M. Cepeda-Jiménez et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Deformation defects and electron irradiation effect in nanostructured Al–Mg alloy processed by severe plastic deformation
- (2012) Man-ping LIU et al. TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA
- Mechanical properties at room temperature of an Al–Zn–Mg–Cu alloy processed by equal channel angular pressing
- (2011) C.M. Cepeda-Jiménez et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Realization of exceptionally high elongation at high strain rate in a friction stir processed Al–Zn–Mg–Cu alloy with the presence of liquid phase
- (2010) K. Wang et al. SCRIPTA MATERIALIA
- Diffusion creep and superplasticity in aluminium alloys
- (2009) K. Sotoudeh et al. ACTA MATERIALIA
- Superplastic behavior of an Al–Mg–Li alloy
- (2009) Lingying Ye et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Superplasticity, dynamic grain growth and deformation mechanism in ultra-light two-phase magnesium–lithium alloys
- (2009) F.R. Cao et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- High strain rate superplasticity in continuous cast Al–Mg alloys prepared via friction stir processing
- (2009) M.A. García-Bernal et al. SCRIPTA MATERIALIA
- Contribution of grain boundary sliding in low-temperature superplasticity of ultrafine-grained aluminum alloys
- (2009) F.C. Liu et al. SCRIPTA MATERIALIA
Add your recorded webinar
Do you already have a recorded webinar? Grow your audience and get more views by easily listing your recording on Peeref.
Upload NowBecome a Peeref-certified reviewer
The Peeref Institute provides free reviewer training that teaches the core competencies of the academic peer review process.
Get Started