Processing Parameter Effects on Residual Stress and Mechanical Properties of Selective Laser Melted Ti6Al4V

Effect of scanning strategies on residual stress and mechanical properties of Selective Laser Melted Ti6Al4V

(2018) Haider Ali et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

In-situ residual stress reduction, martensitic decomposition and mechanical properties enhancement through high temperature powder bed pre-heating of Selective Laser Melted Ti6Al4V

(2017) Haider Ali et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

Study on the microstructure, mechanical property and residual stress of SLM Inconel-718 alloy manufactured by differing island scanning strategy

(2015) Yanjin Lu et al.   OPTICS AND LASER TECHNOLOGY

Spatial variation of melt pool geometry, peak temperature and solidification parameters during laser assisted additive manufacturing process

(2014) V. Manvatkar et al.   MATERIALS SCIENCE AND TECHNOLOGY

An Experimental Investigation into Additive Manufacturing-Induced Residual Stresses in 316L Stainless Steel

(2014) Amanda S. Wu et al.   METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE

Selective laser melting of Ti6Al4V alloy for biomedical applications: Temperature monitoring and microstructural evolution

(2013) I. Yadroitsev et al.   JOURNAL OF ALLOYS AND COMPOUNDS

Effects of processing parameters on tensile properties of selective laser melted 304 stainless steel

(2013) Kai Guan et al.   MATERIALS & DESIGN

An anisotropic enhanced thermal conductivity approach for modelling laser melt pools for Ni-base super alloys

(2012) Shakeel Safdar et al.   APPLIED MATHEMATICAL MODELLING

On the mechanical behaviour of titanium alloy TiAl6V4 manufactured by selective laser melting: Fatigue resistance and crack growth performance

(2012) S. Leuders et al.   INTERNATIONAL JOURNAL OF FATIGUE

On selective laser melting of ultra high carbon steel: Effect of scan speed and post heat treatment

(2012) M. A. Taha et al.   MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK

Assessing and comparing influencing factors of residual stresses in selective laser melting using a novel analysis method

(2012) Jean-Pierre Kruth et al.   PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE

Influence of process parameters on part quality and mechanical properties for DMLS and SLM with iron-based materials

(2011) Jordi Delgado et al.   INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

On the delamination and crack formation in a thin wall fabricated using laser solid freeform fabrication process: An experimental–numerical investigation

(2009) Masoud Alimardani et al.   OPTICS AND LASERS IN ENGINEERING