Study on the crack nucleation mechanism of Ti-2Al-2.5Zr alloy in low cycle fatigue: Quasi in-situ experiments and crystal plasticity simulation
出版年份 2023 全文链接
标题
Study on the crack nucleation mechanism of Ti-2Al-2.5Zr alloy in low cycle fatigue: Quasi in-situ experiments and crystal plasticity simulation
作者
关键词
-
出版物
INTERNATIONAL JOURNAL OF PLASTICITY
Volume 165, Issue -, Pages 103604
出版商
Elsevier BV
发表日期
2023-03-31
DOI
10.1016/j.ijplas.2023.103604
参考文献
相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。- Effects of temperature and microstructure on low cycle fatigue behaviour of a PM Ni-based superalloy: EBSD assessment and crystal plasticity simulation
- (2022) W.T. Zhang et al. INTERNATIONAL JOURNAL OF FATIGUE
- Strain localization and crack initiation behavior of a PM Ni‐based superalloy: SEM‐DIC characterization and crystal plasticity simulation
- (2022) Rong Jiang et al. FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES
- On the mechanism of fatigue crack initiation in high-angle grain boundaries
- (2022) Veronika Mazánová et al. INTERNATIONAL JOURNAL OF FATIGUE
- Effect of macrozones on fatigue crack initiation and propagation mechanisms in a forged ti-6Al-4V alloy under fully-reversed condition
- (2022) Fabien Briffod et al. Materialia
- Multi-dimensional study of the effect of early slip activity on fatigue crack initiation in a near-α titanium alloy
- (2022) Conghui Liu et al. ACTA MATERIALIA
- Micromechanical fatigue experiments for validation of microstructure-sensitive fatigue simulation models
- (2022) Ali Riza Durmaz et al. INTERNATIONAL JOURNAL OF FATIGUE
- Micromechanical behavior of Ti-2Al-2.5Zr alloy under cyclic loading using crystal plasticity modeling
- (2022) Shengkun Wang et al. INTERNATIONAL JOURNAL OF FATIGUE
- Intergranular fatigue crack initiation in polycrystalline copper
- (2022) Alice Chlupová et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Microstructure-based Multiscale and Heterogeneous Elasto-plastic Properties of 2205 Duplex Stainless Steel Welded Joints: Experimental and Modeling
- (2022) Zhilong Dong et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Quantification of α phase strengthening in titanium alloys: Crystal plasticity model incorporating α/β heterointerfaces
- (2022) Mengqi Zhang et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Experimental and crystal plasticity modelling study on the crack initiation in micro-texture regions of Ti-6Al-4V during high cycle fatigue tests
- (2021) Wencheng Liu et al. INTERNATIONAL JOURNAL OF FATIGUE
- Effects of Al content and α2 precipitation on the fatigue crack growth behaviors of binary Ti–Al alloys
- (2021) Sabry S. Youssef et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Experiment and non-local crystal plasticity finite element study of nanoindentation on Al-8Ce-10Mg alloy
- (2021) Jiahao Cheng et al. INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES
- Study on deformation mechanism of Ti-2Al-2.5Zr alloy tube in the flattening test
- (2021) Shengkun Wang et al. JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY
- Cyclic plasticity of an interstitial high-entropy alloy: Experiments, crystal plasticity modeling, and simulations
- (2020) Xiaochong Lu et al. JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS
- Examining metrics for fatigue life predictions of additively manufactured IN718 via crystal plasticity modeling including the role of simulation volume and microstructural constraints
- (2020) Veerappan Prithivirajan et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Investigations of micro-notch effect on small fatigue crack initiation behaviour in nickel-based alloy GH4169: Experiments and simulations
- (2020) Guang-Jian Yuan et al. INTERNATIONAL JOURNAL OF FATIGUE
- A non-local crystal plasticity constitutive model for hexagonal close-packed polycrystals
- (2020) Omid Sedaghat et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Predicting dwell fatigue life in titanium alloys using modelling and experiment
- (2020) Yilun Xu et al. Nature Communications
- The effects of heat treatment on the response of WE43 Mg alloy: crystal plasticity finite element simulation and SEM-DIC experiment
- (2020) Sriram Ganesan et al. INTERNATIONAL JOURNAL OF PLASTICITY
- On the crack initiation and heterogeneous deformation of Ti-6Al-4V during high cycle fatigue at high R ratios
- (2019) Ritwik Bandyopadhyay et al. JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS
- Micromechanical Modelling of the Influence of Strain Ratio on Fatigue Crack Initiation in a Martensitic Steel-A Comparison of Different Fatigue Indicator Parameters
- (2019) Benjamin Josef Schäfer et al. Materials
- Characterizing microscale deformation mechanisms and macroscopic tensile properties of a high strength magnesium rare-earth alloy: A combined experimental and crystal plasticity approach
- (2019) A. Githens et al. ACTA MATERIALIA
- Validation of micro-mechanical FFT-based simulations using High Energy Diffraction Microscopy on Ti-7Al
- (2018) Vahid Tari et al. ACTA MATERIALIA
- Study of slip activity in a Mg-Y alloy by in situ high energy X-ray diffraction microscopy and elastic viscoplastic self-consistent modeling
- (2018) Leyun Wang et al. ACTA MATERIALIA
- Slip transfer and deformation structures resulting from the low cycle fatigue of near-alpha titanium alloy Ti-6242Si
- (2018) Sudha Joseph et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Dislocation interactions and crack nucleation in a fatigued near-alpha titanium alloy
- (2018) S. Joseph et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Quantitative investigation of micro slip and localization in polycrystalline materials under uniaxial tension
- (2018) Zhen Zhang et al. INTERNATIONAL JOURNAL OF PLASTICITY
- The role of defects and critical pore size analysis in the fatigue response of additively manufactured IN718 via crystal plasticity
- (2018) Veerappan Prithivirajan et al. MATERIALS & DESIGN
- Crystal plasticity modelling and HR-DIC measurement of slip activation and strain localization in single and oligo-crystal Ni alloys under fatigue
- (2017) Yongjun Guan et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Micromechanical modeling of fatigue crack initiation in polycrystals
- (2017) Martin Boeff et al. JOURNAL OF MATERIALS RESEARCH
- Microstructurally sensitive crack nucleation around inclusions in powder metallurgy nickel-based superalloys
- (2016) J. Jiang et al. ACTA MATERIALIA
- Influence of complex LCF and dwell load regimes on fatigue of Ti–6Al–4V
- (2016) P.O. Tympel et al. ACTA MATERIALIA
- An HR-EBSD and computational crystal plasticity investigation of microstructural stress distributions and fatigue hotspots in polycrystalline copper
- (2016) V.V.C. Wan et al. ACTA MATERIALIA
- Microstructure-sensitive fatigue crack nucleation in a polycrystalline Ni superalloy
- (2016) V.V.C. Wan et al. INTERNATIONAL JOURNAL OF FATIGUE
- Slip activities in polycrystals determined by coupling DIC measurements with crystal plasticity calculations
- (2016) Adrien Guery et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Resolving geometrically necessary dislocation density onto individual dislocation types using EBSD-based continuum dislocation microscopy
- (2016) T.J. Ruggles et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Influence of local crystallographic configuration on microcrack initiation in fatigued 316LN stainless steel: Experiments and crystal plasticity finite elements simulations
- (2016) L. Signor et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Identification of crystal plasticity parameters using DIC measurements and weighted FEMU
- (2016) Adrien Guery et al. MECHANICS OF MATERIALS
- Crystal Plasticity Model Validation Using Combined High-Energy Diffraction Microscopy Data for a Ti-7Al Specimen
- (2016) Todd J. Turner et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- On the mechanistic basis of fatigue crack nucleation in Ni superalloy containing inclusions using high resolution electron backscatter diffraction
- (2015) Jun Jiang et al. ACTA MATERIALIA
- Ncorr: Open-Source 2D Digital Image Correlation Matlab Software
- (2015) J. Blaber et al. EXPERIMENTAL MECHANICS
- A crystal plasticity FE model for deformation with twin nucleation in magnesium alloys
- (2015) Jiahao Cheng et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Microstructure and mesh sensitivities of mesoscale surrogate driving force measures for transgranular fatigue cracks in polycrystals
- (2015) Gustavo M. Castelluccio et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- A dislocation-based cyclic polycrystalline visco-plastic constitutive model for ratchetting of metals with face-centered cubic crystal structure
- (2014) Yawei Dong et al. COMPUTATIONAL MATERIALS SCIENCE
- A stored energy criterion for fatigue crack nucleation in polycrystals
- (2014) V.V.C. Wan et al. INTERNATIONAL JOURNAL OF FATIGUE
- Grain-scale experimental validation of crystal plasticity finite element simulations of tantalum oligocrystals
- (2014) H. Lim et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Polycrystal Plasticity: Comparison Between Grain - Scale Observations of Deformation and Simulations
- (2014) Reeju Pokharel et al. Annual Review of Condensed Matter Physics
- The physics of fatigue crack initiation
- (2012) Michael D. Sangid INTERNATIONAL JOURNAL OF FATIGUE
- Micromechanics of crystallographic size-effects in metal matrix composites induced by thermo-mechanical loading
- (2012) Ramin Aghababaei et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Characterization of fatigue crack-initiation facets in relation to lifetime variability in Ti–6Al–4V
- (2011) Sushant K. Jha et al. INTERNATIONAL JOURNAL OF FATIGUE
- Modeling the fatigue crack growth behavior of Ti-6Al-4V by considering grain size and stress ratio
- (2011) Bernd Oberwinkler MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- The role of microtexture on the faceted fracture morphology in Ti–6Al–4V subjected to high-cycle fatigue
- (2010) Ioannis Bantounas et al. ACTA MATERIALIA
- Microstructure-sensitive computational modeling of fatigue crack formation
- (2010) D.L. McDowell et al. INTERNATIONAL JOURNAL OF FATIGUE
- The role of grain boundaries on fatigue crack initiation – An energy approach
- (2010) Michael D. Sangid et al. INTERNATIONAL JOURNAL OF PLASTICITY
- The effect of grain orientation on fracture morphology during high-cycle fatigue of Ti–6Al–4V
- (2009) Ioannis Bantounas et al. ACTA MATERIALIA
- Competing failure modes and complex S–N curves in fatigue of structural materials
- (2009) K.S. Ravi Chandran et al. INTERNATIONAL JOURNAL OF FATIGUE
- Microstructure-sensitive extreme value probabilities for high cycle fatigue of Ni-base superalloy IN100
- (2009) Craig P. Przybyla et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Slip and fatigue crack formation processes in an α/β titanium alloy in relation to crystallographic texture on different scales
- (2008) F. Bridier et al. ACTA MATERIALIA
- On the mechanisms of fatigue facet nucleation in titanium alloys
- (2008) F. P. E. DUNNE et al. FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES
- Microstructural Influences on Very-High-Cycle Fatigue-Crack Initiation in Ti-6246
- (2008) C.J. Szczepanski et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
Create your own webinar
Interested in hosting your own webinar? Check the schedule and propose your idea to the Peeref Content Team.
Create NowBecome a Peeref-certified reviewer
The Peeref Institute provides free reviewer training that teaches the core competencies of the academic peer review process.
Get Started