Effect of Tempering Treatment on Atmospheric Corrosion Behavior of 3Cr13 Martensitic Stainless Steel in Marine Environment

A survey on the passivity of tempered AISI 420 martensitic stainless steel

(2021) Khashayar Morshed-Behbahani et al.   CORROSION SCIENCE

Effect of yttrium addition on microstructure, mechanical and corrosion properties of 20Cr13 martensitic stainless steel

(2020) Qi-yu Zang et al.   JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL

Corrosion Behaviors of Carbon Steel and Ni-Advanced Weathering Steel Exposed to Tropical Marine Atmosphere

(2020) Yueming Fan et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Practical guide to the use of backgrounds in quantitative XPS

(2020) Sven Tougaard   JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A

Influence of heat treatment on the microstructure and corrosion resistance of martensitic stainless steel

(2019) Ingmar Bösing et al.   AIP Advances

Chloride-induced alterations of the passive film on 316L stainless steel and blocking effect of pre-passivation

(2019) Zuocheng Wang et al.   ELECTROCHIMICA ACTA

New insight on early oxidation stages of austenitic stainless steel from in situ XPS analysis on single-crystalline Fe–18Cr–13Ni

(2018) Li Ma et al.   CORROSION SCIENCE

Influence of tempering treatment on microstructure and pitting corrosion of 13 wt.% Cr martensitic stainless steel

(2018) Sunil Kumar Bonagani et al.   CORROSION SCIENCE

Degradation mechanisms in martensitic stainless steels: Wear, corrosion and tribocorrosion appraisal

(2018) A. Dalmau et al.   TRIBOLOGY INTERNATIONAL

Atmospheric corrosion of low carbon steel in a coastal zone of Ecuador: Anomalous behavior of chloride deposition versus distance from the sea

(2018) Juan C. Guerra et al.   MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION

Rapid Tempering of Martensitic Stainless Steel AISI420: Microstructure, Mechanical and Corrosion Properties

(2017) Bijan Abbasi-Khazaei et al.   JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE

Correlative Microstructure Analysis and In Situ Corrosion Study of AISI 420 Martensitic Stainless Steel for Plastic Molding Applications

(2017) Krishnan Hariramabadran Anantha et al.   JOURNAL OF THE ELECTROCHEMICAL SOCIETY

The effect of tempering temperature on the microstructure and electrochemical properties of a 13wt.% Cr-type martensitic stainless steel

(2015) Si-Yuan Lu et al.   ELECTROCHIMICA ACTA

Degradation of austenite stainless steel by atmospheric exposure in tropical marine environment

(2013) H Luo et al.   CORROSION ENGINEERING SCIENCE AND TECHNOLOGY

Formation of magnetite rust particles by reacting iron powder with artificial α-, β- and γ-FeOOH in aqueous media

(2013) Hidekazu Tanaka et al.   CORROSION SCIENCE

Study of the corrosion behavior of weathering steels in atmospheric environments

(2012) Zhifen Wang et al.   CORROSION SCIENCE

Corrosion behaviour of weathering steel in diluted Qinghai salt lake water in a laboratory accelerated test that involved cyclic wet/dry conditions

(2010) J. Wang et al.   MATERIALS CHEMISTRY AND PHYSICS

Corrosion of low carbon steel in atmospheric environments of different chloride content

(2009) Yuantai Ma et al.   CORROSION SCIENCE

Effect of chemical composition, martensite volume fraction and tempering on tensile behaviour of dual phase steels

(2009) Süleyman Gündüz   MATERIALS LETTERS

Microstructure of martensite in Fe–C–Cr steel

(2007) Muneo Yaso et al.   MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING