III‐V//Cu x In 1− y Ga y Se 2 multijunction solar cells with 27.2% efficiency fabricated using modified smart stack technology with Pd nanoparticle array and adhesive material

Measurement and Modeling of 3D Solar Irradiance for Vehicle-Integrated Photovoltaic

(2020) Kenji Araki et al.   Applied Sciences-Basel

Efficient Narrow Band Gap Cu(In,Ga)Se2 Solar Cells with Flat Surface

(2020) Yukiko Kamikawa et al.   ACS Applied Materials & Interfaces

Design of low‐concentration static III‐V/Si partial CPV module with 27.3% annual efficiency for car‐roof application

(2019) Daisuke Sato et al.   PROGRESS IN PHOTOVOLTAICS

Ultrafast growth of InGaP solar cells via hydride vapor phase epitaxy

(2019) Yasushi Shoji et al.   Applied Physics Express

Designing of AlxGa1-xAs/CIGS tandem solar cell by analytical model

(2019) Samaneh Sharbati et al.   SOLAR ENERGY

III‐V//Si multijunction solar cells with 30% efficiency using smart stack technology with Pd nanoparticle array

(2019) Kikuo Makita et al.   PROGRESS IN PHOTOVOLTAICS

A review of recent progress in heterogeneous silicon tandem solar cells

(2018) Masafumi Yamaguchi et al.   JOURNAL OF PHYSICS D-APPLIED PHYSICS

To Do List for Research and Development and International Standardization to Achieve the Goal of Running a Majority of Electric Vehicles on Solar Energy

(2018) Kenji Araki et al.   Coatings

III–V-on-silicon solar cells reaching 33% photoconversion efficiency in two-terminal configuration

(2018) Romain Cariou et al.   Nature Energy

Lithographic fabrication of point contact with Al2O3 rear-surface-passivated and ultra-thin Cu(In,Ga)Se2 solar cells

(2018) Sungwoo Choi et al.   THIN SOLID FILMS

Improvement of Heterointerface Properties of GaAs Solar Cells Grown With InGaP Layers by Hydride Vapor-Phase Epitaxy

(2018) Ryuji Oshima et al.   IEEE Journal of Photovoltaics

Investigation of the open-circuit voltage in mechanically stacked InGaP/GaAs//InGaAsP/InGaAs solar cells

(2017) Takeshi Tayagaki et al.   JAPANESE JOURNAL OF APPLIED PHYSICS

Terawatt-scale photovoltaics: Trajectories and challenges

(2017) Nancy M. Haegel et al.   SCIENCE

Static concentrator photovoltaics for automotive applications

(2017) Taizo Masuda et al.   SOLAR ENERGY

Monolithic Two-Terminal III–V//Si Triple-Junction Solar Cells With 30.2% Efficiency Under 1-Sun AM1.5g

(2017) Romain Cariou et al.   IEEE Journal of Photovoltaics

Raising the one-sun conversion efficiency of III–V/Si solar cells to 32.8% for two junctions and 35.9% for three junctions

(2017) Stephanie Essig et al.   Nature Energy

Palladium nanoparticle array-mediated semiconductor bonding that enables high-efficiency multi-junction solar cells

(2016) Hidenori Mizuno et al.   JAPANESE JOURNAL OF APPLIED PHYSICS

InGaP//GaAs//CIGS 3-junction spectrum-splitting solar cells with low-concentration ratio

(2016) Dong-Won Kang et al.   PHYSICA STATUS SOLIDI A-APPLICATIONS AND MATERIALS SCIENCE

Realization of GaInP/Si Dual-Junction Solar Cells With 29.8% 1-Sun Efficiency

(2016) Stephanie Essig et al.   IEEE Journal of Photovoltaics

GaAs Solar Cells Grown by Hydride Vapor-Phase Epitaxy and the Development of GaInP Cladding Layers

(2016) John Simon et al.   IEEE Journal of Photovoltaics

Current–voltage and spectral-response characteristics of surface-activated-bonding-based InGaP/GaAs/Si hybrid triple-junction cells

(2015) Naoteru Shigekawa et al.   JAPANESE JOURNAL OF APPLIED PHYSICS

Wafer-Bonded GaInP/GaAs//Si Solar Cells With 30% Efficiency Under Concentrated Sunlight

(2015) Stephanie Essig et al.   IEEE Journal of Photovoltaics

Wafer bonded four-junction GaInP/GaAs//GaInAsP/GaInAs concentrator solar cells with 44.7% efficiency

(2014) Frank Dimroth et al.   PROGRESS IN PHOTOVOLTAICS

Two-terminal metal-inter-connected multijunction III-V solar cells

(2014) Chieh-Ting Lin et al.   PROGRESS IN PHOTOVOLTAICS

Fabrication of High-Efficiency III–V on Silicon Multijunction Solar Cells by Direct Metal Interconnect

(2014) Jingfeng Yang et al.   IEEE Journal of Photovoltaics

Comparison of Direct Growth and Wafer Bonding for the Fabrication of GaInP/GaAs Dual-Junction Solar Cells on Silicon

(2014) Frank Dimroth et al.   IEEE Journal of Photovoltaics

Quantitative Assessment of Optical Gain and Loss in Submicron-TexturedCuIn1−xGaxSe2Solar Cells Fabricated by Three-Stage Coevaporation

(2014) Takuya Hara et al.   Physical Review Applied

Metal Pillar Interconnection Topology for Bonded Two-Terminal Multijunction III–V Solar Cells

(2013) W. E. McMahon et al.   IEEE Journal of Photovoltaics

Direct Semiconductor Bonded 5J Cell for Space and Terrestrial Applications

(2013) P. T. Chiu et al.   IEEE Journal of Photovoltaics

Electrical and optical interconnection for mechanically stacked multi-junction solar cells mediated by metal nanoparticle arrays

(2012) Hidenori Mizuno et al.   APPLIED PHYSICS LETTERS

III-V/Si hybrid photonic devices by direct fusion bonding

(2012) Katsuaki Tanabe et al.   Scientific Reports

Multi Junction Solar Cells Stacked with Transparent and Conductive Adhesive

(2011) Toshiyuki Sameshima et al.   JAPANESE JOURNAL OF APPLIED PHYSICS

A Low-Temperature Bonding Process Using Mixed Cu–Ag Nanoparticles

(2010) Y. Morisada et al.   JOURNAL OF ELECTRONIC MATERIALS

Current-matched triple-junction solar cell reaching 41.1% conversion efficiency under concentrated sunlight

(2009) Wolfgang Guter et al.   APPLIED PHYSICS LETTERS

Room-Temperature Bonding of Vertical-Cavity Surface-Emitting Laser Chips on Si Substrates Using Au Microbumps in Ambient Air

(2008) Ryo Takigawa et al.   Applied Physics Express

40.8% efficient inverted triple-junction solar cell with two independently metamorphic junctions

(2008) J. F. Geisz et al.   APPLIED PHYSICS LETTERS

Study of Bonding Technology Using Silver Nanoparticles

(2008) Toshiaki Morita et al.   JAPANESE JOURNAL OF APPLIED PHYSICS