Intercritical annealing to achieve a positive strain-rate sensitivity of mechanical properties and suppression of macroscopic plastic instabilities in multi-phase medium-Mn steels
出版年份 2020 全文链接
标题
Intercritical annealing to achieve a positive strain-rate sensitivity of mechanical properties and suppression of macroscopic plastic instabilities in multi-phase medium-Mn steels
作者
关键词
Medium-Mn steel, Multi-phase steel, Positive strain-rate sensitivity, Servo hydraulic tension, Kolsky bar tension
出版物
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
Volume 803, Issue -, Pages 140469
出版商
Elsevier BV
发表日期
2020-10-30
DOI
10.1016/j.msea.2020.140469
参考文献
相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。- Current Challenges and Opportunities in Microstructure-Related Properties of Advanced High-Strength Steels
- (2020) Dierk Raabe et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- High strength and ductility combination in nano-/ultrafine-grained medium-Mn steel by tuning the stability of reverted austenite involving intercritical annealing
- (2019) Jun Hu et al. JOURNAL OF MATERIALS SCIENCE
- Strain-Rate-Dependent Deformation Behavior and Mechanical Properties of a Multi-Phase Medium-Manganese Steel
- (2019) Simon Sevsek et al. Metals
- Effect of Tempering on the Microstructure and Tensile Properties of a Martensitic Medium-Mn Lightweight Steel
- (2019) Sukjin Lee et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Multi-scale characterization of austenite reversion and martensite recovery in a cold-rolled medium-Mn steel
- (2019) J.T. Benzing et al. ACTA MATERIALIA
- Macro-to nanoscopic in situ investigation on yielding mechanisms in ultrafine grained medium Mn steels: role of the austenite-ferrite interface
- (2019) Binhan Sun et al. ACTA MATERIALIA
- Effects of Hot Band Annealing on the Mechanical Properties of Cold-Rolled and Intercritically Annealed Medium Manganese Steels
- (2019) Radhakanta Rana et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Experimental and numerical study of mechanical properties of multi-phase medium-Mn TWIP-TRIP steel: Influences of strain rate and phase constituents
- (2019) J.T. Benzing et al. ACTA MATERIALIA
- Influence of Microstructural Morphology on Hydrogen Embrittlement in a Medium-Mn Steel Fe-12Mn-3Al-0.05C
- (2019) Xiao Shen et al. Metals
- Temperature dependent strain hardening and fracture behavior of TWIP steel
- (2018) Manjunatha Madivala et al. INTERNATIONAL JOURNAL OF PLASTICITY
- Influence of annealing temperature on microstructure and tensile property of cold-rolled Fe-0.2C-11Mn-6Al steel
- (2018) Z.H. Cai et al. MATERIALS CHARACTERIZATION
- Effects of strain rate on mechanical properties and deformation behavior of an austenitic Fe-25Mn-3Al-3Si TWIP-TRIP steel
- (2018) J.T. Benzing et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Dynamic Strain Aging Phenomena and Tensile Response of Medium-Mn TRIP Steel
- (2018) Daniel M. Field et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Influence of Intercritical Annealing Temperature on Microstructure and Mechanical Properties of a Cold-Rolled Medium-Mn Steel
- (2018) Yan Ma et al. Metals
- Revealing fracture mechanisms of medium manganese steels with and without delta-ferrite
- (2018) Binhan Sun et al. ACTA MATERIALIA
- Effects of intercritical annealing process on microstructures and tensile properties of cold-rolled 7Mn steel
- (2017) Feng Yang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Coincidence of strain-induced TRIP and propagative PLC bands in Medium Mn steels
- (2017) Michael Callahan et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Medium-manganese steels processed by austenite-reverted-transformation annealing for automotive applications
- (2017) Yan Ma MATERIALS SCIENCE AND TECHNOLOGY
- Influence of Temperature and Grain Size on Austenite Stability in Medium Manganese Steels
- (2017) Yulong Zhang et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Discontinuous strain-induced martensite transformation related to the Portevin-Le Chatelier effect in a medium manganese steel
- (2017) Binhan Sun et al. SCRIPTA MATERIALIA
- Failure of metals III: Fracture and fatigue of nanostructured metallic materials
- (2016) André Pineau et al. ACTA MATERIALIA
- The mechanism of hydrogen embrittlement in intercritically annealed medium Mn TRIP steel
- (2016) Jeongho Han et al. ACTA MATERIALIA
- Failure of metals I: Brittle and ductile fracture
- (2016) A. Pineau et al. ACTA MATERIALIA
- Fabrication of bimodal-grained Al-free medium Mn steel by double intercritical annealing and its tensile properties
- (2016) Jeongho Han et al. JOURNAL OF ALLOYS AND COMPOUNDS
- Dependence of deformation behavior on grain size and strain rate in an ultrahigh strength-ductile Mn-based TRIP alloy
- (2016) M.H. Cai et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Analysis of the Tensile Behavior of 12 pct Mn Multi-phase (α + γ) TWIP + TRIP Steel by Neutron Diffraction
- (2016) Sangwon Lee et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Microstructural Characterization of a Fe-25Mn-3Al-3Si TWIP–TRIP Steel
- (2016) J T Benzing et al. MICROSCOPY AND MICROANALYSIS
- Nanolaminate transformation-induced plasticity–twinning-induced plasticity steel with dynamic strain partitioning and enhanced damage resistance
- (2015) M.-M. Wang et al. ACTA MATERIALIA
- The influence of stacking fault energy on the microstructural and strain-hardening evolution of Fe–Mn–Al–Si steels during tensile deformation
- (2015) D.T. Pierce et al. ACTA MATERIALIA
- Correlation between mechanical properties and retained austenite characteristics in a low-carbon medium manganese alloyed steel plate
- (2015) Jun Chen et al. MATERIALS CHARACTERIZATION
- Enhancing Hydrogen Embrittlement Resistance of Lath Martensite by Introducing Nano-Films of Interlath Austenite
- (2015) Meimei Wang et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Fe-25Mn-3Al-3Si TWIP-TRIP Steel Deformed at High Strain-Rates
- (2015) J. T. Benzing et al. MICROSCOPY AND MICROANALYSIS
- The effects of the initial martensite microstructure on the microstructure and tensile properties of intercritically annealed Fe–9Mn–0.05C steel
- (2014) Jeongho Han et al. ACTA MATERIALIA
- The influence of manganese content on the stacking fault and austenite/ε-martensite interfacial energies in Fe–Mn–(Al–Si) steels investigated by experiment and theory
- (2014) D.T. Pierce et al. ACTA MATERIALIA
- Strain partitioning in ultra-fine grained medium-manganese transformation induced plasticity steel
- (2014) P.J. Gibbs et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Current opinion in medium manganese steel
- (2014) Y.-K. Lee et al. MATERIALS SCIENCE AND TECHNOLOGY
- Strain Hardening and Strain Rate Sensitivity Behaviors of Advanced High Strength Steels
- (2013) F Ozturk et al. JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL
- Intercritical rolling induced ultrafine microstructure and excellent mechanical properties of the medium-Mn steel
- (2013) R. Zhang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Work Hardening Behavior in Steel with Multiple TRIP Mechanisms
- (2013) M. C. McGrath et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- On the Selection of the Optimal Intercritical Annealing Temperature for Medium Mn TRIP Steel
- (2013) Seawoong Lee et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Transmission Electron Microscopy Analysis of Yielding in Ultrafine-Grained Medium Mn Transformation-Induced Plasticity Steel
- (2013) Bruno C. De Cooman et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Revealing the strain-hardening behavior of twinning-induced plasticity steels: Theory, simulations, experiments
- (2012) David R. Steinmetz et al. ACTA MATERIALIA
- High-Strain-Rate Deformation: Mechanical Behavior and Deformation Substructures Induced
- (2012) George T. (Rusty) Gray Annual Review of Materials Research
- Deformation microstructures and strengthening mechanisms of an ultrafine grained duplex medium-Mn steel
- (2012) Chang Wang et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- On the origin of dynamic strain aging in twinning-induced plasticity steels
- (2011) Seok-Jae Lee et al. ACTA MATERIALIA
- Work hardening behavior of ultrafine-grained Mn transformation-induced plasticity steel
- (2011) Seawoong Lee et al. ACTA MATERIALIA
- A Kolsky tension bar technique using a hollow incident tube
- (2011) O Guzman et al. MEASUREMENT SCIENCE and TECHNOLOGY
- Localized Deformation in Multiphase, Ultra-Fine-Grained 6 Pct Mn Transformation-Induced Plasticity Steel
- (2011) Seawoong Lee et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Dependence of tensile deformation behavior of TWIP steels on stacking fault energy, temperature and strain rate
- (2010) S. Curtze et al. ACTA MATERIALIA
- Processing Opportunities for New Advanced High-Strength Sheet Steels
- (2010) David K. Matlock et al. MATERIALS AND MANUFACTURING PROCESSES
- The effect of grain size and grain orientation on deformation twinning in a Fe–22wt.% Mn–0.6wt.% C TWIP steel
- (2010) I. Gutierrez-Urrutia et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Hole expansion of advanced high strenth steel sheet sample
- (2010) L. Xu et al. International Journal of Material Forming
- Enhanced Mechanical Properties of a Novel High-Nitrogen Cr-Mn-Ni-Si Austenitic Stainless Steel via TWIP/TRIP Effects
- (2009) M. Pozuelo et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Derivation and Variation in Composition-Dependent Stacking Fault Energy Maps Based on Subregular Solution Model in High-Manganese Steels
- (2009) A. Saeed-Akbari et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Effect of Strain Rate on the Yield Stress of Ferritic Stainless Steels
- (2008) Kester D. Clarke et al. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE
- Influence of addition elements on the stacking-fault energy and mechanical properties of an austenitic Fe–Mn–C steel
- (2007) A. Dumay et al. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
Find the ideal target journal for your manuscript
Explore over 38,000 international journals covering a vast array of academic fields.
SearchCreate your own webinar
Interested in hosting your own webinar? Check the schedule and propose your idea to the Peeref Content Team.
Create Now