Electrokinetic and gel behavior of Si3N4 aqueous suspension

Surface modification of ultrafine silicon nitride powders by calcination

(2019) Zhentao Ni et al.   International Journal of Applied Ceramic Technology

Nondestructive and fined characterization of injection molded ceramic parts by industrial computed tomography

(2019) Hehan Xie et al.   CERAMICS INTERNATIONAL

3D characterisation of indentation induced sub-surface cracking in silicon nitride using FIB tomography

(2019) A. Baggott et al.   JOURNAL OF THE EUROPEAN CERAMIC SOCIETY

Surface characterization of silicon nitride powder and electrokinetic behavior of its aqueous suspension

(2019) Zhentao Ni et al.   CERAMICS INTERNATIONAL

Powder modification mechanism, effects of binder compositions on the thermal behavior, and the mechanical properties of the ceramic injection molded system

(2018) Wei Liu et al.   CERAMICS INTERNATIONAL

Effects of the binder compositions on the homogeneity of ceramic injection molded compacts

(2018) Jiaxin Wen et al.   CERAMICS INTERNATIONAL

Preparation of c-axis textured SiC ceramics by a strong magnetic field of 6T assisted gel-casting process

(2016) Zhigang Yang et al.   CERAMICS INTERNATIONAL

Comparison of aqueous and non-aqueous tape casting of fully stabilized ZrO2 suspensions

(2015) Martin Michálek et al.   POWDER TECHNOLOGY

Characterization of silicon nitride thin films deposited by hot-wire CVD at low gas flow rates

(2013) Clive J. Oliphant et al.   APPLIED SURFACE SCIENCE

Influence of feedstock preparation on ceramic injection molding and microstructural features of zirconia toughened alumina

(2013) Frank Sommer et al.   JOURNAL OF THE EUROPEAN CERAMIC SOCIETY

Fracture behavior of silicon nitride ceramics under combined compression–torsion stresses analyzed by multiaxial fracture statistics

(2011) N. Kawai et al.   JOURNAL OF THE EUROPEAN CERAMIC SOCIETY

Neural network modeling and analysis of gel casting preparation of porous Si3N4 ceramics

(2009) Juanli Yu et al.   CERAMICS INTERNATIONAL