A study on extruded filament bonding in fused filament fabrication

Parametric optimization of intra- and inter-layer strengths in parts produced by extrusion-based additive manufacturing of poly(lactic acid)

(2017) Martin Spoerk et al.   JOURNAL OF APPLIED POLYMER SCIENCE

Estimation of filament temperature and adhesion development in fused deposition techniques

(2017) S.F. Costa et al.   JOURNAL OF MATERIALS PROCESSING TECHNOLOGY

On the use of high viscosity polymers in the fused filament fabrication process

(2017) Muhammad Hussam Khaliq et al.   RAPID PROTOTYPING JOURNAL

Weld formation during material extrusion additive manufacturing

(2017) Jonathan E. Seppala et al.   Soft Matter

Numerical investigation of the influence of process conditions on the temperature variation in fused deposition modeling

(2017) Jie Zhang et al.   MATERIALS & DESIGN

The impact of process parameters on mechanical properties of parts fabricated in PLA with an open-source 3-D printer

(2015) Antonio Lanzotti et al.   RAPID PROTOTYPING JOURNAL

Influence of Layer Thickness and Raster Angle on the Mechanical Properties of 3D-Printed PEEK and a Comparative Mechanical Study between PEEK and ABS

(2015) Wenzheng Wu et al.   Materials

Fused deposition modeling with polypropylene

(2015) O.S. Carneiro et al.   MATERIALS & DESIGN

On reducing anisotropy in 3D printed polymers via ionizing radiation

(2014) Steven Shaffer et al.   POLYMER

A review of melt extrusion additive manufacturing processes: I. Process design and modeling

(2014) Brian N. Turner et al.   RAPID PROTOTYPING JOURNAL

Characterization and modeling of sintering of polymer particles

(2010) M. Asgarpour et al.   JOURNAL OF APPLIED POLYMER SCIENCE

Effect of processing conditions on the bonding quality of FDM polymer filaments

(2008) Q. Sun et al.   RAPID PROTOTYPING JOURNAL