Gloss of thermally densified alder (Alnus glutinosa Goertn.), beech (Fagus sylvatica L.), birch (Betula verrucosa Ehrh.), and pine (Pinus sylvestris L.) wood veneers

Thermo-mechanical densification of wood is performed to improve physical and mechanical properties of wood. During this treatment aesthetic properties of wood, including gloss, also change. Therefore, the purpose of this study was to determine the effect of short-term thermo-mechanical (STTM) densification in different wood species (alder (Alnus glutinosa Goertn.), beech (Fagus sylvatica L.), birch (Betula verrucosa Ehrh.), and pine (Pinus sylvestris L.)) on their gloss changes. Commercial wood veneers were densified in a hot plate press for 4 min at temperatures of 100, 150 and 200 A degrees C, pressures of 4, 8 and 12 MPa. Gloss was evaluated at 20A degrees, 60A degrees and 85A degrees angles of incident light using PICO GLOSS 503. Gloss measurements showed an enhancement of aesthetic properties of densified wood. Findings of this study indicated that both densification temperature and pressure have a significant effect on wood gloss. Gloss values of densified wood increased with increasing densification temperature and pressure for all investigated species. Compared to non-densified wood, gloss (85A degrees) values (across/along the grain) for alder, beech, birch and pine increased after treatment to 2109.1/2376.9, 1728.6/2311.1, 2787.5/3000, and 2591.7/1216.7 %, respectively. The greatest gloss values were recorded at 200 A degrees C and pressure of 12 MPa for all tested angles of incident light and for all densified wood samples. Gloss changes for birch were the highest, but the glossiest surface was observed for pine among all investigated species after wood densification.