Surface tension and density data for Fe-Cr-Mo, Fe-Cr-Ni, and Fe-Cr-Mn-Ni steels

The temperature dependence of surface tension and density for Fe-Cr-Mo (AISI 4142), Fe-Cr-Ni (AISI 304), and Fe-Cr-Mn-Ni TRIP/TWIP high-manganese (16 wt% Cr, 7 wt% Mn, and 3-9 wt% Ni) liquid alloys are investigated using the conventional maximum bubble pressure (MBP) and sessile drop (SD) methods. In addition, the surface tension of liquid steel is measured using the oscillating droplet method on electromagnetically levitated (EML) liquid droplets at the German Aerospace Centre (DLR, Cologne). The data of thermophysical properties for Fe-Cr-Mn-Ni is of major importance for modeling of infiltration and gas atomization processes in the prototyping of a TRIP-Matrix-Composite. The surface tension of TRIP/TWIP steel increased with an increase in temperature in MBP as well as in SD measurement. The manganese evaporation with the conventional measurement methods is not significantly high within the experiments (a dagger(Mn) < 0.5 %). The temperature coefficient of surface tension (d sigma/dT) is positive for liquid steel samples, which can be explained by the concentration of surface active elements. A slight influence of nickel on the surface tension of Fe-Cr-Mn-Ni steel was experimentally observed where sigma is decreased with increasing nickel content. EML measurement of high-manganese steel, however, is limited to the undercooling state of the liquid steel. The manganese evaporation strongly increased in excess of the liquidus temperature in levitation measurements and a mass loss of droplet of 5 % was observed.