Effect of needle geometry on flow rate and cell damage in the dispensing-based biofabrication process

Increased Mixing Improves Hydrogel Homogeneity and Quality of Three-Dimensional Printed Constructs

(2010) Daniel L. Cohen et al.   TISSUE ENGINEERING PART C-METHODS

PAM2 (Piston Assisted Microsyringe): A New Rapid Prototyping Technique for Biofabrication of Cell Incorporated Scaffolds

(2010) Annalisa Tirella et al.   TISSUE ENGINEERING PART C-METHODS

Modeling of Flow Rate, Pore Size, and Porosity for the Dispensing-Based Tissue Scaffolds Fabrication

(2009) M. G. Li et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME

Modeling Process-Induced Cell Damage in the Biodispensing Process

(2009) Minggan Li et al.   TISSUE ENGINEERING PART C-METHODS

A brief review of dispensing-based rapid prototyping techniques in tissue scaffold fabrication: role of modeling on scaffold properties prediction

(2009) M G Li et al.   Biofabrication

Rheological Properties of Cell-Hydrogel Composites Extruding Through Small-Diameter Tips

(2008) Jie Cheng et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME

Modeling of the Flow Rate in the Dispensing-Based Process for Fabricating Tissue Scaffolds

(2008) X. B. Chen et al.   JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME

Effects of Dispensing Pressure and Nozzle Diameter on Cell Survival from Solid Freeform Fabrication–Based Direct Cell Writing

(2008) Robert Chang et al.   TISSUE ENGINEERING PART A